Great video. I use your video as a reference to change my broken cup holder. The face plate of the USB and AUX ports is made out of brittle plastic. It may rip off when prying from the front. (Mine did) It is best to push it out from the back and then disconnect the wires. Anyone changing just the cup holder, you do not have to remove the gear knob. Have someone tilt the console up after removing the the bolts and screws. Feel for five T20 screws that attaches the cup holder to the console.

I cannot thank you enough for taking the time to make this video. You are the man!

Great video, I don't think I'd attempt removing my centre console with this video! I think I would have given up and not tried to wrap my centre console. I am going to give this a try this weekend. Once again, thank you for this video!

Finally a quality video on this

Very good video bro couldn't have made it simpler 👍 thanks

Great video very useful replacing my arm rest

Great video

Hi bro i'm korean I saw this video it was helpful Thx :)

great video. straight to the point and very informative

Very very helpful 👍 Thanks

great video thank youuu

Thanks a lot man.

Super thanks 😊

Great video, although for the gear knob, I would actually remove the leather dust cover from the console first and then unlock the gearknob and pull straight up without pressing the button. If the button is pressed whilst it is out of the shift stick, it will be hard to reset. Also its easier to unlock the gearknob without having to reach your hand between the wires etc.

Hey man, nice video. I'm swapping to the S6 carbon trim. I'd love to see how you did the roof liner.

Thanks for this. I have a C7 A7 and want to replace the dinged aluminium in the centre too. Already had the rear off before to fix the vent actuators in the rear. I 'm guessing once the whole unit is out I can then remove the centre trim (Wood in your case) and reverse. I was hoping it would be easier, though it doesn't look too involved - just make sure you don't miss any clips for wires I guess?

Thanks for the video. Is there any way you could get the front wooden panels out without taking the whole console out?

Hi, thanks for making this video. I have to replace the cover of the front coffee holder unit which is broken. Is there an easy way to get to that without going through removing the whole centre console unit.

I dropped something in behind the cup holder door will doing all this get to that part ?

I have a question I took off the shift knob once I replaced it back the release trigger to put it drive , reverse, neutral doesn’t spring to release it’s just spring at all how do you fix that

Hi, at 4:19, that green cable connected to AMI is that from USB ports? I have no power suply on usb port. Replaced the unit and same story? Could it be a cable fault or MMI have some sort of power management disabled for that matter?

hello all this job to change the alluminium trim ont the front? can you tell me the tool part number to use ?thanks

Bro good video! You showed everything clearly! I am also looking to swap my interior trims, have brushed metallic but it’s all scratched up and has little bumps in the centre console, do u recommend any repair/-replacement options?

Would this also work on a 2016 A6?

Once the front tray is out, is it possible to remove the wood trim (main U shaped piece) without taking the whole centre console out? I'm looking to replace mine with brushed aluminium rather than a wrap

How the hell did you pull out that headliner?

Do you plan on doing a video for the upper dash trim/HUD removal? This was a very simple but informative video. I'm hoping you have something on it.

Hi, can anyone tell me if this is the same as a A6 7.5, looks very similar and have to do this job myself this week

Did you ever do another video showing how to remove the other trim panels?

Do you have this wooden interior decor for sale?