You didn’t hold the button long enough the first time. You need to hold it for a solid 1.5-2 seconds for it to start. The last time, you went a lot slower and it worked.

Ok, I had a 2016 JGC Summit and it kept doing the same thing. I changed the batteries both of them , that wasn’t the issue. I changed the fuse control module it worked for a while but it went out again. When I traded the vehicle they explained to me that it was the Control module ..... make sure you check out this vehicle before you purchase it. I had to trade mine within 3 months. It was in the shop over 4 times in 3 months .......

Is the problems with the brake. The Brake sometimes gets hard or gets air in it so it don’t engage quick, that’s why it won’t start because it needs both to start. I just hit the break harder and it works fine.

Fuel pump...no pressure

How did you reset

You right about that I had to leave my jeep behind even with a jump. It did not want to start up because it was running hot, but it did not show on the dashboard that it was running hot. It said it was the cooler was higher, was running higher, I think it was the airbag system, the electric park brakes it needs to be serviced It was just too much to bear. but all that to say that car need to be updated with thesoftware that’s probably was causing the car to behave the way it is I’m not a mechanic, but Lord without a software updated it is shutting the car down and that’s probably what’s going on with all vehicles

You have to hold the button and pressing the brake

Had the same problem. I changed the battery and started $500 later the problem was the same. It was the switch on / off button🤦🏻‍♀️

Had similar issue , would click into ACC and RUN but wouldn’t crank, had to change the battery

It seems you only switch to ACC. Engine will not start that way. If you push the button long enough, like 1.5-2 seconds then it will start the engine. That’s the basic step of push button FOB keys. Hope it helps. 😀

How did u fixed that just start on my car

It was my starter in my case

I have same issue 2014 grand Cherokee summit. I don't know why it is not working. I see message service electronic breaking system. I try what is in this video and it start working

So I guess you have a reset button you didn’t show us

Close the door

Win module seem to be the issue

Area 215 $120.00 Diagnostic Plus Parts and Labor

My 2016 Jeep does the same. Displays 'Service electronic Parking System' and it only starts when I jump start it. What could this be?

Not holding it long enough 🤦🏻‍♂️🤦🏻‍♂️

So did you ever find out why it wouldnt start in the beginning? Im having the same issue but mine wont start at all.

What are the symptoms of a bad head gasket? My car engine locked up and just won’t start. Firestone told me that it’s the head gasket. The car only have 88k mile on it and it’s a 2018 JGC.

Changed my battery in my 16 cherokee and battery saver mode came on. Why?

SMH hold it down for 2 seconds u goober

You need to change the batteries in your key mechanism!

My 2017 Summit V6 is having absolutely disgusting battery issues or something with the alternator, maybe even spark plugs i cant put a finger on it yet, but its driving me nuts. Its stalled out at a red light right before Im about to go and traffic starts honking at me while i furiously mash the start button. Its embaressing. This thing was once a smooth machine.

push the brake pedal harder, trust

My car did the same I took it to the repair and they said dead battery

I share your aggravation. 2019 Jeep renegade pos. Sometimes won’t start. Cranks and cranks. And when it decides to start, it run’s just fine. Until it won’t start again. Never again will I purchase anything related to mopar

Reset what? What’s the point of this video? It’s not helpful at all. Might as well. Take it down pointless you don’t show no one anything.

Keep buying American

Sounds to me like it won't start

Cuz cherokees are junk!!! 😂