This is how easy it is to swap out the Seymour Duncan jb in the bridge for the original burstbucker 3 using the quick connects.
Пікірлер: 4
@michaeld27167 ай бұрын
Thank you. Very interesting. I have to watch a few times to get it all.
@ScottPaine7 ай бұрын
Cool. If you have questions about anything just let me know.
@20120310 Жыл бұрын
Hello sir, thanks for your video, I have 2017 standard with same pcb board, but it’s weird the pick is coil split when the knobs are down, not pull up. I’m wondering if something was wired reversed. Maybe the wires from pickup to quick connects were wrong? Thanks if you can give me some suggestions
@ScottPaine Жыл бұрын
I haven't heard of that problem before. Is it a 2017 HP (High Performance) or a 2017 Traditional Spec.? Both Trad spec. and HP have a circuit board but they are different. The HP has 5 little dip switches attached to the circuit board. I would have to take a closer look and see if there is anything soldered to the push/pull or if it is plugged into the push/pulls. If there are wires soldered to the push/pulls then they just put the hot in the wrong spot but if it's plugged into the pots I wouldn't know what the issues is. Did you CALL GIBSON? Even though it's past the 2 years for electronics warranty it is a factory defect and they should send you a new circuit board.