2021 Aprilia RS660 | Carbon Smith Velocity Stack & DNA Filter Install

Рет қаралды 29,086

Күн бұрын

Пікірлер: 52

@SongJLikes Ай бұрын

Alright, I just gotta say, if you are getting the UpMap for your rs660, get the Sprint P08 air filter… Gabro tuned the maps to a set up with that sprint air filter specifically… and once I got a sprint air filter installed, the tune lined up perfectly… no more wheezing on the front end , the transmission/quick shifter is WAY smoother, and 1st and 2nd gear are now far more usable than ever before… and I swear, fuel consumption is more efficient even though it feels like more power is being generated The vibrations are more cohesive/symphonic now, though a bit heavier than before my CR-T/flash tune/air filter install

@WarrensAdventures 3 жыл бұрын

Looking forward to seeing the Dyno numbers!!

@A7XBilly 3 жыл бұрын

Allrighty! DNA Greek Filters installed in the beautiful RS660! Greetings from Greece!!🇬🇷

@deweysturgill6220 3 жыл бұрын

Just shifted the powercurve upwards with the shorter trumpets. The only advantage is the slightly better entry radius the carbons have. Definitely an item that would have been nice to dyno test with an ecu reset, before adding the exhaust. The air filter is pretty good noticed a very slight gain mid to top with mine. It will actually improve after the ecu adjust fuel trims to it. Great content as always.

@affitness1 3 жыл бұрын

Pre-ordered my black/red one yesterday! #5 of 12 coming to WA on the 1st round of shipments, can’t wait! So glad I found your channel; this makes my upgrade/customizations so much easier to choose, thanks for great content!

@kku487 3 жыл бұрын

@@CaliMotoTV hi man, sand me the web for buy it pls

@flybyguy1450 3 жыл бұрын

Shorter velocity stacks should lend towards improved intake scavenging at higher rpm. Might net you a few horsepower when combined with a proper exhaust and tune. Can't wait to see the final hp and tq numbers!

@SteinerSE 3 жыл бұрын

Just watched another video of someone installing the SC project exhausts on a 2021 RS 660 and they seemed to conclude that removing the radiator when installing the exhaust was the way to go. (very restricted room and risk of damaging the radiator). Listening to SCP exhaust in yet another video and it sounds soo sweet.

@hotbox76 3 жыл бұрын

Not required, just remove the three screws holding the radiator and it hangs far enough to provide plenty of room. No need to remove the radiator at all. Helps to have a folding ratchet.

@ManAndMachine23 2 жыл бұрын

No need to pull the whole tank off,just take the side black plastics off,same one you take off for shock adjustment,lift the tank enough to get a wrench to the bolt, I used a shop towel under the tank to keep the tank up,while I worked. Thank for the vid man!

@CaliMotoTV 2 жыл бұрын

👍

@brandonfloyd4962 3 жыл бұрын

Your stacks need to be swapped with shorter on the left because it won’t fit correctly on the right due to the airbox has a bump that holds it up from fitting all the way in.

@49Motors 2 жыл бұрын

Just ran into the same issue, checked the video and his left side stack is seen not making full contact with the bottom. Thought it was just me

@allthekidsareright 3 ай бұрын

Do you have carbon smiths? did you notice an improvement?

@gamingradius8057 3 жыл бұрын

When is the 800cc big bore kit coming??😂😂😂

@fausch Жыл бұрын

Really good DIY video man, subscribing for more!

@manufitnss1025 3 жыл бұрын

making those changes with the limited bike, will you notice the difference?

@MrDavidRacer 2 жыл бұрын

great videos 👍🏻👍🏻👍🏻 could you make a video about the spark plug change on the RS660? Greetings from Austria 🇦🇹

@CaliMotoTV 2 жыл бұрын

Sold the bike sorry.

@mattyjlove7157 2 жыл бұрын

Thanks for your work. Does the intake noise is now louder? I am hoping so.

@CaliMotoTV 2 жыл бұрын

Yea it got a little louder.

@Mrfacts_ge 3 жыл бұрын

Nice introduction 😍👌😎💥

@JuanAntonioAdrover 3 жыл бұрын

Hey Bill! I have been in touch with SC lately and they recommend remapping. SC does not provide a map. Which one will you install? Thanks!

@JuanAntonioAdrover 3 жыл бұрын

@@CaliMotoTV I see, I can’t wait to see the sc installed with the stacks and filter 😉

@JuanAntonioAdrover 3 жыл бұрын

@@CaliMotoTV I am holding my decision about ordering the Akrapovic or the SC and it depends on you an Victor! Can’t wait for those vids! Thanks for your content! 😉

@kwsk5660 3 жыл бұрын

What happens for the velocity stack screws if they get loose? 🙂 Aftermarket ones may be should have the same securing as in OEMs

@rudedog3529 3 жыл бұрын

They should have, at least , used a drop of Blue Loctite on each screw.

@kwsk5660 3 жыл бұрын

@@rudedog3529 I would do the same, actually had long thinking about the similar case when changed air filter to Fireblade

@Bhavincis 3 жыл бұрын

Liked and subscribed.

@andreabasaglia8699 3 жыл бұрын

Grazie!

@needmetal3221 3 жыл бұрын

Inverted golf balls. I'm curious about the numbers too

@benjaminhatfield5606 3 жыл бұрын

excellent video, would it be possible to list where we can purchase the items from? thank you

@Thept09rider_ 3 жыл бұрын

Cali do you know if this dimpled velocity stanks are only installed with stock exhaust? Other question, can we install this kit in a Tuono 660?

@johnswanson6790 3 жыл бұрын

I’m late to the party here, and at the risk of asking an old question, does the work you’re doing void any warranty on this bike?

@invalidscope3602 3 жыл бұрын

How does the sound change when driving when you accelerate? as soon as you accelerate with the 660 (under load) a deep sound comes out. how about the new air filter? Volume up? different sound?

@dariopellegrino2668 3 жыл бұрын

Do you need to pump the gas out or is it possible to do it with gas inside the tank?

@400chevlc 3 жыл бұрын

What kind of HP improvement are you expecting?

@Itzp4tt 3 жыл бұрын

Cali Moto I have the same bike as yours. But the other day I broke my safety clutch switch installing the ASV levers, and order the part do you think it will be hard to out them on.

@Itzp4tt 3 жыл бұрын

@@CaliMotoTV thank you hopefully it get here soon haven't riden here that much. Loved what you doing on the RS660. Hopefully to see you at the track one day.