I just turn it to 5psi as the instructions say to keep it at that, and it feels stock.

It’s been great. However, some of the comments on this thread have lead me to reach out to Firestone. I’m hoping to have an updated video posted in a few days. Basically they’ve designed and released new brackets and supplemental instructions (that also need to be corrected). I’ll discuss a little in the upcoming video.

See my above response to my comment.

Same… lol

So I just installed this kit on my 2021 f350 king ranch and looks like you put the inside bracket that goes against the leaf spring on upside down. When I went to use the bottom bracket on the drivers side there was a bracket that holds a bunch of brake cables and such in the way on the axle. So I actually had to cut the corner off the bottom bracket at an angle so it would fit. Not super user friendly that’s for sure.

Yeah, I ordered another kit. While I don’t have the original instructions any longer, I’m inclined to think the instructions have had a revision. I remember going back and fourth off camera about this step…. As soon as I have time I’ll update.

The other thing I found that the instructions were wrong about was that they say the bags need to be put in the front hole on the upper support bracket but that would have really made them off center to the rest of the set up. So using the rear hole lined up way better for me. 🤷🏽‍♂️

I think you’re onto something. I looked under the truck and noticed a bad is not in the intended position any longer. The top is more forward of the truck while the rear is still in position. Thanks for the heads up. I noticed your name had horse in it…. Check out my other channel I’m starting to spin up. youtube.com/@OakLineFarm

Okay, I finally got around to looking into this more. My install was correct. The updated instructions include both installs for Jounce brackets and Non-Jounce brackets. Since I have Jounce brackets, the way I installed was correct. However, they now are suppose to include an additional part. A rubber puck that sits inside the large spacer. I'm pretty sure this rubber puck not being there is exactly why my bag slipped. Scroll to the bottom and there is a series of instructions and tech bulletins. However, the full black/white instructions are incorrect for Jounce Stop Bracket versions. The paper copy with the kit are accurate. What a mess they've caused.