this brings me back to transmission apprentice days. good ol' times I want to go back to.
@eggzotiq4 жыл бұрын
thank you very much for clear directions and clean camera footage. This information was what i was looking for...
@TheTrothKeeper3 жыл бұрын
x2 TY sir!
@biglu5102 жыл бұрын
How do you replace shift solenoid for code p2714?
@sebastianwise6567 Жыл бұрын
I have a 2011 Chevy Suburban 1500 LT. The code is P2723 pressure control solenoid Valve 5 stuck off I was told I would have to replace my whole transmission module. Was thinking maybe it could be more simple. Hope you can help me
@Urbanmsllc11 ай бұрын
Hey there. I have the same issue on my 2015 Tahoe LT and was told the same. What did you end up doing if I may ask?
@JesseBotello2 жыл бұрын
Great video I appreciate you .
@FLbowtieguy9 ай бұрын
Do you know symptoms of a bad pressure switch.. and would you have a cel light on
@michealalmalik18811 ай бұрын
I have a problem shifting third to second roughly will that help replace valve body chevy express 3500 2018 6.0l
@brandonnguyen1486 Жыл бұрын
At 3:36, that lever... I broke that tryin to get my trans pan out on my 2014 sierra 5.3 4x4. I think it's pulled down. So what's gonna happen if I just replaced the filter and bolt everything back up and let it ride? Because it seems like you still need those torq bits to be unbolted for the valve body to drop
@chrisgarcia1845 Жыл бұрын
Great video.
@Frankreddy623 жыл бұрын
Thank you for the excellent video. Is it really that easy ?? I will be tackling this project next weekend.
@asylummotorsports59973 жыл бұрын
It's pretty easy. I hope all went well with yours.
@jamesethan37492 ай бұрын
80 and 90 are the same? 🤔
@CHRIS72WS64 жыл бұрын
Hello sir, and thank you very much for this clear video. I followed your directions but now my 6l80 is very sluggish and it seems to be stuck in 3rd gear. Any info on that issue? Thank you.
@Spahi772 жыл бұрын
Doubt he is answering at this point ...lol
@heathermoon7860 Жыл бұрын
What am I supposed to do when the tcm clip is stuck open???
@moldypizza88085 ай бұрын
Lmao
@robertstinson27004 жыл бұрын
So, I got the thing apart and replaced my pressure switches but I cannot seem to press the connector back over the wiring harness without forcing it? Help...
@Spahi772 жыл бұрын
See Chris response above ....your SOOL
@fernandobernal2887 Жыл бұрын
Hi I just replace my valve body I follow all the steps put it back but now my transmission is not shifting the light of the dash dont change to any rear neautral or drive do I need to do a reprogram? Please help me
@hussain8820 Жыл бұрын
yes
@eronic404 Жыл бұрын
Have you found a solution?
@shadow69584 ай бұрын
Same issue did you figure it out?
@mike2323909 Жыл бұрын
So where is the shift solenoid located at for this transmission ?
@armsongs Жыл бұрын
Do you need to reset after replacing it.
@DIABLO_4_Tester_Sacramento2 жыл бұрын
Dear sir, could you please advise. I have stock 6L80 on my 2011 chevy camaro SS. I found UPDATED Valve Body Spacer Plate w/ 8 Check Balls 10-Up. Can I use it on my stock car?
@asylummotorsports59972 жыл бұрын
Yes.
@Daltonm234 Жыл бұрын
Where did you buy this from and how much? If so can you please send me the link pressure solenoid 5 is bad in my trans and need to buy the part
@andrewduffett30522 жыл бұрын
Hi I have the 6l90 in my truck. My question is , the plastic pass through connector......does it have to be removed before the valve body will drop out.....or will it come out as is
@asylummotorsports59972 жыл бұрын
It will come out as is, you just have to wiggle it.
@OkayAhhgain3 жыл бұрын
So Getaway cars rebuilds them? I can seem to find them online, do you have a link
@asylummotorsports59973 жыл бұрын
getawaycarz.com/
@waissatar306 Жыл бұрын
Hey is this for chevy camaro 2010
@_skiin Жыл бұрын
WHERE DO YOU SEND IT FOR REBUILD?
@OSCARCAPETILLO073 жыл бұрын
What’s the torque foot per pound
@MichaelGonzalez-sm8cb10 ай бұрын
What are the torque specs of the 6 bolts on the valve body?
@edgarosorio2155 ай бұрын
18ft lbs
@eastcoastkickz4891 Жыл бұрын
When should you change this?
@bluej3335 ай бұрын
Your VB only when it needs it
@reynaldosanchez28813 жыл бұрын
can you remove techum without removing valvebody ?
@asylummotorsports59973 жыл бұрын
No sir, you cannot.
@GabeDT5673 жыл бұрын
What is the part numbers for the all shift solenoids and TCC solenoid and where to get them?
@asylummotorsports59973 жыл бұрын
The solenoids cannot be changed, they are part of the THECM.
@Vettespeed2 жыл бұрын
@@asylummotorsports5997 oh that’s a bummer I’m pretty sure my solenoids are bad
@cv25882 жыл бұрын
@@asylummotorsports5997 does this include the pressure control sensor solenoid?
@Mr2pac200010 ай бұрын
@@asylummotorsports5997 is the pressure control solenoid in this valve body?
@helloautomotive44352 жыл бұрын
Ur gonna sleep outside the house because of that camera man joke
@COFFEE-e3p9 ай бұрын
FROM THE BOTTOM OF THE TRUCK IT LOOKS PRETTY NEWISH, , IF THATS THE CASE , ITS A REAL SHAME WE HAVE TO CHANGE OUT A VALVE BODY, INSTEAD OF COMPUTERS BEING A BENEFIT TO US ITS ONLY BENEFIT TO THE DEALER AND THE SHOPS, DAM SHAME $$$$$ .