Thankyou for watching. CHECK OUT MERCH HERE! the-gray-mechanic.printify.me/ the-gray-mechanic.myspreadsho...
Пікірлер: 41
@mechanicgray7 ай бұрын
Thanks for watching. MERCH LINK IN DESCRIPTION.
@ChiefDLK24 күн бұрын
I've pulled my transmission several times and am about to do it again for a rebuild. It always takes longer. I don't have a lift so I am stuck doing it on the ground which adds a lot of getting up and down off the ground. The standing up and laying down is the worst part of having to do it. I like the order you did the removal, so I will likely incorporate that into how I do it this weekend.
@mechanicgray24 күн бұрын
I agree. Doing this on the ground is twice as hard. Good luck. 👍
@sbirddesmo3 ай бұрын
Starting a pull on a '17 for a friend today. I'm going to do what you did. Thanks much!
@mechanicgray3 ай бұрын
Hope it helps. If you have questions put them here and I will respond. 🤘
@kill3rhorsepow3r514 ай бұрын
Ayyy farmers repair coming in clutch to aid in my install 🙌🏻 prolly be easier to have yall install my new one 😅
@Thep3524 ай бұрын
Thank you so much for this video man
@mechanicgray4 ай бұрын
My pleasure. Thanks for watching.
@nolankeffer30997 ай бұрын
Perfect this is what im talking about great video!
@mechanicgray7 ай бұрын
Thank you for watching
@waynethompson830612 күн бұрын
16:55 great uncut video of the trans, thank you. Question do you need to learn/read the old trans and write to the new one on the 6L 80?
@mechanicgray12 күн бұрын
Yes. If you change the transmission it needs to be programmed.
@MattsGarageАй бұрын
First, thank you. This is extremely helpful. Second, where do you find those slide in adapters for the transmission jack head that create those vertical standoffs for the oil pan bolt rail flange? I can't find them anywhere!
@mechanicgrayАй бұрын
Hey no problem. I'm not sure where we got them. I'll ask and let you know.
@JuseJamezАй бұрын
Cheverlot has swapped my trans twice. 2nd time it was under warranty. The first time it was 3 days after an oil change which had me puzzled. It was working fine until that oil change. Now… 3 weeks after that transmission swap. 3 bolts have broken and my engine makes a weird noise. 3500 dollars. I need a bicycle.
@mechanicgrayАй бұрын
Damn that sucks. Don't think the oil change had to do with it. Sometimes stuff just happens at wired times.
@elmerkerth3871Ай бұрын
I like watching your video seems like I might be able to take mine out
@mechanicgrayАй бұрын
Thanks 👍 Hope it helps
@brandeneskridge23182 ай бұрын
When you put a brand new transmission in a 2015 Silverado 1500, does the new transmission have to be programmed to the vehicle? I heard someone say it does, but idk for sure. Reason for asking, my trans is going out and I wanna know ahead of time. Thanks in advance!
@mechanicgray2 ай бұрын
Yes. The TCM is inside the Transmission and will need to be programmed to the truck. If you are doing the job yourself make sure you also flush the transmission cooler. The most common problem with these is the torque converter fails. It then puts a bunch of metal in the cooler.
@jessetorres63173 ай бұрын
Does the truck have to be left in neutral to spin the motor and remove convertor bolts?
@mechanicgray3 ай бұрын
No. I do put it in neutral though to be able to turn the drive shaft so its easier to take the bolts out.
@ivanvega60715 ай бұрын
Is it possible to replace the plug in on the transmission?
@mechanicgray5 ай бұрын
Yes. It's part of the valve body harness that is located in the pan.
@devongrubb96345 ай бұрын
“Then I go get a buddy to help lower it down” 😂😂😂😂cuhmon buddy it’s like a 80 pound t case at most.
@mechanicgray5 ай бұрын
Im only 155. 80 is enough 😂😂😂
@thenotsojollyrancher-akate95163 ай бұрын
You can put a strap on it and over the torsion bar support and slowly let down by strap.
@yawningdoodle2 ай бұрын
Was this a 5.3 or a 4.3 engine?
@mechanicgray2 ай бұрын
5.3L
@phillipdrake43715 ай бұрын
I don’t like the way you lifted the truck the arms facing the same way, did you do that on purpose or you never have a problem with the lift ?
@mechanicgray5 ай бұрын
Not sure what you mean
@phillipdrake43714 ай бұрын
The lift arms facing same way
@phillipdrake43714 ай бұрын
I’m doing a tranny in a 2020 4wd Silverado same set up as your video thanks for the video
@mechanicgray4 ай бұрын
@@phillipdrake4371 You welcome. Thanks for watching.
@dl10152 ай бұрын
2017 does it need to be programmed
@dl10152 ай бұрын
It’s a manufactured transmission
@mechanicgray2 ай бұрын
Yes it will need to be programmed.
@dl10152 ай бұрын
So I would need to take it to a dealership after the new manufacture transmission is installed
@dl10152 ай бұрын
@@mechanicgray I would need to take it to a dealership after installing a new manufacturer transmission
@mechanicgray2 ай бұрын
@@dl1015 Or find a mobile programmer in your area. A nearby transmission shop should know someone. 👍