Best instructions very detailed and clear! Much love bro!

if you file down the plastic around where the ac controls are just a little bit and put another 1/4” spacer behind the controls it fits perfectly

I forgot I was watching a installation video when the movie started 😂 I was legit into the movie 😂😂

Excellent how-to video. I appreciate your detailed explanations. You have done a world of good.

Exactly the info I was looking for. Thank you for the video.

Awesome. Just picked up a ‘00 Silverado. Going to start upgrading it as well. New sub here so I can follow along

Ok few notes about this who wants to do this. I've done the swap just like in the video and i want to share my experience. I have a 2002 GMC Yukon XL SLE. For starters i DON'T have the big center console i have the middle seat. Everything was running smooth until i had to take out the radio bucket. I couldnt reach the bottom bolt since the little bottom panel blocks the bolt. So glovebox and the driver side footwell panel thingy had to come out in order to get to it. Next, the 03-06 radio bucket fits in there pretty good just a little tight fit, the climate control is a tight squeeze in the radio bucket itself so it may want to pop out a little bit but once you get it in its all good. The last and biggest thing is the 03-06 dash bezel does not have a good fit on the right side (towards the radio and climate vents) since it's a little taller when put into place the little coin holder thing can no longer be opened, its stuck closed, and the car chargers are hard to see because the little flap cant open all thr way. Also it doesnt clip in on the bottom right all the way because of the glovebox panel, in the 2002's and older its a little bulkier and higher compared to the later models so i had to trim the bezel with a dremel on the bottom right side just to get it to clip in some what. Everything i said will also apply to 02 and older models with the center console as well because the coin holder, glove box and car charger ports are all in the exact position as models without the center console and its the same parts. If you dont mind everything i just said go ahead and do the swap but if you do mind don't do it. Personally it doesn't bother me toooo much but im going to swap in the old radio bucket without the metal bracket so that the double din can fit and buy a double din dash bezel. Either way good video

The most informative video on a conversion I've seen. Great job.👍

For anybody who is planning on doing this. You don’t have to cut off the bottom left screw hole. You can actually just cut the radio cage where it hits it. And still use the screw hole. Also. If you have an ashtray i took the plastic off of mine with a philips screwdriver and it still hits the bezel when i try to open it. So if u wanna keep the ashtray you probably have to shave a very slim piece off the bottom of the bezel which is what i might do. Also my bezel was wedged up against the button on the left side of the climate control and was pressing it down so i had to shave a little off and u can’t even tell and the button is free now. I might just shave that whole side of the climate control hole so it will fit the climate control better. And instead of braking the clips off of the climate control, just shave them down and make them flat so you can use them as your spacers.

Nice clean install. I have an 04 Silverado and I'm thinking about this stereo upgrade. I have the factory CD / Cassette in my truck. My CD player doesn't work but the Radio and Cassette player does. Good video , Thanks for the information !

You are a lifesaver bro so detailed! Thank You!

Thanks for the detail video im about to get rid of my 03 yukon and have a 01 was trying to see how to do all this 👌 your video help out alot

I take it that my 03 Silverado will be a cake walk. Lol hey if you get a chance let us know how that radio works for ya. I like the price point. Thanks for the video, very detailed.

Liked the video. It would be nice if the music was the same volume as the Rest of the video. With headphones it’s super loud and annoying to switch to the music and a much higher volume.

Absolutely fantastic job (kudos to your camera man also)! Definitely subscribed...

that tattoo on your hand is fire

Most excellent Sir!!!

I bought the pioneer dmh1770nex its only a head unit no cd player. you don't have to do any of the radio bucket mods only have to modify the outer bezel or buy the prefabbed bezel for a double din. I just plug my phone in and never play cds

This is an awesome video great job I'm doing this to my truck

Looks great, thanks for info

Thank you sir !! 👍🏼

You explain everything like a pro ..

i enjoyed the video. I have an escalade console,

😁Thats a dope hand tatt bro.

Thanks for sharing..nice job

Have you figured out how to wire in the factory sub for the 00-02 style?

Wow your awesome man wish you would of done the wires tho

Great informative video

So basically, you just basically basically the basically to the basically and that’s basically it. Basically.

where did you get the 03 bezel and bucket? I have an 02 and am planning on doing the same swap.

Great video best I’ve seen. Love the info

My 2000 Silverado has an extra set of cables that are mostly green and red coming from the side of the driver

good video man, would you happen to know how to convert a truck like that to a/c

This worked perfectly but I’m trying to install my reverse camera where would I connect the purple wire ?

I know this video is old, but I am trying to do this, but I can't get the rivets out. I tried drilling, tried hiting like you said I can't get it . HELP

Under rated video 👍 great work

Was that a metra dash kit bezel or was it out an 03+?

great video helped a lot

my 2001 2500 hd has 2 plugs on the back of the radio 1 goes to the body module if you just plug up a radio the guages stop working

Great video bro !! 👍👍👍new sub !!

Thank's.... i have a 2000 suburban that i want to put the double din in.

Nice video help me a lot to figure out were to connect the wire to see movie also were can i get the paint to colormatch the center console

is the dash bezel from a 03 as well?

Hey, have an 02 im fixing to do this to. What double din dash kit did you use metra or? Also whats the diameter of the opening for radio? Will it hold a 178mm x 100mm? Thanks great video!

Thanks for the video man it helped out a lot Iam just trying to figure out how you connected the toggle switch for the ground for the videos

I wonder how many times a day you say "baysilly"

Do you know how to drive a 5 speed manual?

Where did you get your charcoal gray dye? Could you post a link?

Hey man just wondering could you have used the original bezel ? If you cut that piece on the bar like you had talked about ?

Yeah my lazy ass gonna buy a flip out haha.

You didn't have to remove the stereo mounting bracket but that's not the point good video

There was no issue with the ac control module fitting? I am doing the conversion on my truck and the ac control seems a little to wide is there something else that you did besides just putting the wheel choke rubber as a spacer

Nice Job Dude!! Fu*k Crutchfield, I’m a DIY kind of guy as well!!

When is the video to power doors coming !

do you have the link to the stereo u used im trying to put this in my 2001 chevy silverado

so if I want to also add a backup cam. to my tail gate will it connect up to the new radio and show on the screen???

I'm not a fan of tattoos, but the shift pattern one is a neat idea!

Run the green wire to the ground on the radio harness...

Awesome vid 👍🏼

Do you really even need the bar?

SHIT I'VE NEVER THO OF THIS. IM HITTING THE YUNK YARD THIS WEEKEND.

What does the metal bracket do?

Does anyone know if a 10” touch screen head unit will fit in an 02 Silverado obviously with a double din conversion. I haven’t measured mine and I’m a bit impatient and I want to order my radio.

Where can I get the gauge Bessel?

What if I don't have a e brake

I have a 2000 slivereydo and I’m guna head to junk yard get parts

Can you change the climate control from the one you have to a 2006 with little digital screen?

What size is the radio 71”?

I saw another video that did it way easier. But it was on a tahoe

I’ve never been big into audio systems into my trucks, so what is a den and a double den?

Will this conversion work on a 97 Sierra PU Regular Cab

Is the radio supposed to go all the way in? My seems to hit the back. I cut the bar where it would block. Just wondering, confused

What was the purpose of the toggle switch

You in Texas ? Can I pay you to this for me?

They sell a aftermarket dash bezel one just for your truck

can i have the old radio

Did you hook up the Bose Amp & Sub While you were in there?

Can I just use a shit ton of washers?

Brother, I have to address this...you hacked the F* out of this...I'm smart. #1: just cut the top off on the radio housing. #2: cut the angle of the steel flat rod. Fits fine.

By the time you can drill one rivet I'll be done by reaching in there with pliers and breaking what I need out. That step adds entirely too much time.

Just seeing all that on the hood makes me cringe

Puros takuaches aki cuhhhhh

Why the heck does everyone want to put the 03 radio bucket in it? Why can't we do it with the 99-02 bucket? why must we damage our dash in order to do a radio swap? It feels so wasteful and stupid to me. Want to change the radio on my 01 Suburban and everyone is like "Gotta cut here and here and here and swap out this entire part for the new part because we think everyone has a ton of disposable income and can afford to mangle their oem parts."

Lmao 5 speed tattoo cuz you can't handle 6 gears

get a kit off crutchfield.com dont waste all your time doing it this way lol

Great another distracted driver watching a DVD while driving, who uses DVD's any more anyways.