99 Yamaha GP800 Oil Block Off Plate

Рет қаралды 9,677

4 жыл бұрын

This video is how to install an oil block off plate by SBT on a 99 Yamaha GP 800. The block off plate makes it so that I can run premixed fuel to guarantee that I am getting the proper mix. Most people don't realize that their oil pump went bad until they blow their motor.
Oil Block Off Kit:
www.shopsbt.com/jetski/seadoo...
Copyright free music from SoundCloud:
Lost Sky Feat. Jex - Where We Started [NCS Release]
/ lost-sky-feat-jex-wher...

Пікірлер: 21

@R1Ryder 4 жыл бұрын

Loved the video man!💪🏻

@DaveMedicus 4 жыл бұрын

Thank you I appreciate it. Thanks for watching!!!

@Jjsupermman Жыл бұрын

You are god sent thank you 🙏

@DaveMedicus Жыл бұрын

Glad it helped. Thanks for watching

@solais33 4 жыл бұрын

Best video

@DaveMedicus 3 жыл бұрын

Thank you. I wasn't planning of filming it but I noticed all of the other videos sucked. lol I would recommend still mixing the fuel to the factory ratio to help eliminate problems. Many people advised me I didn't need that much but 20 hours later I ran into problems.

@MrAnythinggood 4 жыл бұрын

What oil and premix are running? Did you do any other carb changes like removal of the accelerator pump.

@DaveMedicus 3 жыл бұрын

I was running quicksilver for a while at 32:1 then was told that 50:1 was all I needed. Big mistake in my opinion. 40:1 would have been better for me. I did switch to Amsoil and only made it two tanks before the motor locked up on me with 20 hours. I haven't torn it apart yet to find out how much damage there is.

@pabloflores6328 Жыл бұрын

@@DaveMedicus did the engine lock up after change to 50:1 premix?

@jamesmoore6864 Жыл бұрын

Did you have to mess with the carbs after installing the block off plate or was it ready to go with the factory set carb?

@DaveMedicus Жыл бұрын

Nope

@Xprototype12x Жыл бұрын

Do you have any idea why my gp800 starts and idles fine and revs up out of water but when we drop it in lake it will only rev up like quarter to half throttle and won’t go over 20mph

@alexbennett3515 Жыл бұрын

Had the same problem. No pressure in the fuel tank. Check your check valve on your fuel sending unit on the tank, gas chap o ring. And fuel sending unit rubber housing for cracking

@DaveMedicus 4 ай бұрын

Resistance requires more fuel. Most likely a fuel related issue. Thanks for watching!

@williamsteinhour4876 Жыл бұрын

Do you have to do anything to the computer so it doesn't beep all the time?

@DaveMedicus Жыл бұрын

I left oil in the tank so that the sensor doesn't keep going off.

@williamsteinhour4876 Жыл бұрын

@@DaveMedicus My issue is the computer thinks it's low all the time I have replaced the sensor twice and the computer, still beeps. I even took it to a Yamaha dealer and they couldn't fix it. They also replaced the sensor and computer and same results. grrrr.... They called me to come get it at no charge. I love the ski.... but it's driving me nuts.