You can find replacement parts here: AC Receiver Drier/Accumulator/Dehydrator: amzn.to/2YOPuBr Pressure Switch Sensor: amzn.to/3eQRkan O-rings: amzn.to/38gU2DL (These are Amazon affiliated links)

Your videos are wonderful. I really appreciate the clear angles showing everything you are doing. There are far to many dark, shaky videos about fixing cars on youtube. Good work!

Thank you very much for taking your time to make these videos as they have been very helpful and informative. You saved me a good amount of headaches and money.

Hi, have Infiniti M45 2010. Issue - AC-clutch not engaging. Parts look the same. Can I replace the low pressure switch without evacuating the system?

Great video, very well explained. I have a question, on the replacement drier I bought, under it it says 'IN' for one of the pipe entrance. In which one should this go to? It didn't had that one the original factory one.

Great video!! Thank you for posting. What is the tube called on the opposite side of the condenser? Do you have a video on how to change that one?

Take bottom bolt off 1st in case it’s in there tight. If you take off clamp 1st and bottom bolt is tight it will twist and break the lines off

Another fine tutorial, thanks so much!

very informative, thanks a lot

Great Video! I have a question maybe you can help me with. I have a 2011 Nissan Altima, SR V6. There is no power going to the A/C compressor. The compressor was replaced as well as the HVAC System switch and the Heater Temperature AC Climate Control. I know the A/C works because I had some help after recharging the system we connected the A/C straight to the battery and works great. I've also checked the a/c relay as well and its working fine. I cannot figure out why there is no power going to the A/C compressor.

Awesome tutorial ac receiver drier. Thank youl

I bought 2008 Nissan Altima in this winter and I knew that my AC don't work when I found the oil leakage under condenser and receiver drier . Do I need to change receiver drier or not. What happen and what to do ? Thank you.

Thank you so much. You give me very good information.

Do we hve to clean the condensor when replacing dryer?

Hello, your video is very good. One question, I have a 2015 Nissan rogue select and I want to change only the Pressure Switch Sensor, do I also have to empty the Gas, or can it be done?

Great video. My 2007 sentra has not had it's AC working for 7 years. When it stopped working 7 years ago the dealership said it had a condenser leak. I bought a spare condenser which come with AC dryer. Would you recommend replacing anything else? Also if I replace the AC dryer condenser and then drive to shop next day to have system recharged and oiled, is that too much of a wait. I assume there is moisture and oxygen in the AC system as it was open for 7 years?

Is there one of these videos for an 04 Xterra.

Great video quality and easy to follow!! Have one question... Do you have the o-rings sizes for the AC dryer and condenser?

That plate was installed upside down under the dryer. I know from experience. Cause all my refrigerant to leak. Lmao I first uninstalled it the correct position and was watching your video and did it because you did it because I was questioning myself. Well I flipped it and the o rings were able to seal properly. No more leak.

I really appreciate this video 📹🙌 great job 👍 👏

Your videos are very good and easy to understand. I'm looking for the Expansion Valve Replacement video but could not find it on You Tube site. Can you please help me?

hi I have 2008 Altima hybrid I have only .52 volt at pressure switch on signal wire. my ac compressor not coming on. what should be lo side psi when compressor not working. thank you

Hi your videos are great, I replace the compressor also yesterday I try to vacuum the system but idk if I put the drier in the right position? honestly I didn't pay attention how the old drier goes, stupid mistake, I saw freon coming out from this area, thanks.

Can you use any small screw and not for that??? My screw to the old one won't fit on the new one I bought.

Thank you for your help!!!

Is this similar to the 06 Altima?

Hi... Thanks for above video and information... I need your help in how to remove the hup from the Ac blower motor shaft (the hup is plastic not a clib or nut) an this is the problem.

My 2011 Altima just started leaking oil from compressor yesterday.. after I replaced the pulley ( it was warped ) So do I really need to replace the receiver and and expansion valve ??? It's only 5 years old.. and it was blowing perfectly nice Cold air.. Oil looks new to.. I'm thinking just compressor and recharge ?

Great clear videos Sir! Question, those O-rings looked very loose and a little different in size, did you have any issues by chance? I saw some other people who have had issues with the aftermarket O-rings like this..

Does it matter how you mount the drier onto the condenser? i just swapped mind and was confused as to how to put on the dried both holes align perfectly, and hoping it was done correctly.

nice job

Great content man i have problem in my 08 altima V6 which is the compressor keep working until the evaporator freezes and air flow becomes weak till i disengage the ac manually do you by any chance know a solution..?

Thank you sir......

Is it safe to crank the car up to recharge ac system even though it has been evacuated...

Where is this part/assembly on a 2014 Murano? What engine is that, 2L or bigger? Working on a 2014 3.5L Murano, AC just quit 1 day. - thanks, take care.

Do you know what could cause (for the same vehicle) the ac to blow cold air and after a while of it being on , goes back to blowing hot air ? I’ve been told it could be the expansion valve or the pressure switch

Hi I have a question I replace my radiator and my condenser AC was working before they went out now that I replaced it in my AC stopped working do you think might needs to be recharged

Was your ac compressor working before you changed anything?

Super

Hey my Ac is not working on my Infiniti m45 06. Clutch is not Spinning and I was wondering if I change the AC low pressure switch would the AC Compressor kick on or do I need a new compressor??

Hello,after this job i must be change the ac air?

Hey, it's me again lol did you have to add any oil after replacing the receiver drier or expansion valve? I'll be replacing the expansion valve while I'm there. If so, what kind of oil? PAG 46? What oil did you use to lubricate the o rings? Lol sorry, I just want to do the job right, first time.

My AC on my 07 Altima works when I first start it and then it goes out about 5 miles down the road. Turn off the engine and restart it and the AC works again. Do you know what the issue could be???

Hi I have a question my compressor work I have my ac change but I don’t have a cool air I would like to know if you have a idea what could be my car is a 2014 Nissan Altima thanks!!! Please if you can help me!!!

Can I replace the low pressure switch without having to empty the system?

Sir I have a question ... I have the Nissan Juke 2015 I checked and inside most connection looks same as in the movie ... in my case Once the car warms up to operating temperature and I'm in park with the car idling, the compressor comes on for 5-10 seconds and then off for 5-10 seconds. It just continues with that cycle. If I turn the climate OFF everything its normal. IM SO CONFUSE ... its the A/C Pressure Sensor Switch fault, the HEATER CLIMATE CONTROL SWITCH PANEL fault, the sensors inside the cabin fault ??... I went to dealer and good trick the mechanic turned the climate off and everything went fain Dealer diagnose nothing going on with a 36000 miles Nissan Juke 2015. When back home I turned the climate ON and again the compressor comes on for 5-10 seconds and then off for 5-10 seconds. I know I'm not craz... I want to fix it but I don't know what to do. I checked the pressure for AC its normal in the spec ... I schedule appointment at AC Nissan Mechanic for full diagnoze. Please help What Can Be?

Why did you change the drier only? What symptoms did your car have

Nice vedio.can you tell me why I change the drier. What is the sign telling me that you have had dier

How are you doing. I have a 2010 nissan altima and the compressor went out. I replaced it, recharged the ac and its still blowing hot air. Do you think it can be the condenser and sensor?

I have a nissan Altima08 everytime i cut ac on it cuts my car off .do u know wat may b problem

My 99 Ford ranger has a leak in the ac. They added dye could not find any said it was probably the dryer and said would cost 1500. Seems like a easy job at least on that car 1500 seems excessive

Good

Hello. How empty the sistem ac please.

Good video I have same color altima 2008

i have a 02 i35 infiniti, nissan and infiniti are identical basically, my AC blows hot air, my compressor works, the shop told me the compressor is just pushing metal shavings out and said i need to replace compressor dryer and extension valve, does this sound right? also my coolant fans dont work but half the time, could it really be the fans and not the AC system thats at fault?

I need you help I got Nissan Altima 2'5 a.c no Work

Thank you soon much for another wonderful video you are great but Nissan and these crooked automotive mechanics are not these crooks will not get my money today.

I have nissan dayz roox 2015 that car have ac problem on idle compressor is working but when i press break padal on drive gear position compressor continues on an off working

How will you know it's time to have it replaced?

Hello I have a 2011 nissan maxima is it possible to remove the a/c high pressure switch without removing all the freon from the system thanks.

I have a Nissa Altima s 2013 and its AC is blowing hot air. The AC was recharge but still blowing hot air.

where the location of reciever drier in toyota corolla small body 1990 model

Do you absolutely have to replace AC receiver drier?

dear i have a nissan altima 2008 3.5L i have a problem with the ac that when i turn on the ac on the car the compressor work directly but the cold air will delay for maybe 5 to 10min to begin flowing knowing that the air blowing will start from the sec you turn on the ac only im having delay in the cold air blowing.

I have nissan micra 1.6SR, my car air conditioning not working

3:49 I'm sorry i couldn't help seeing that hit xD lol

How you know the sensor is bad,?

I have 2008 altima 3.5, ac compressor clutch was not engaging...fuses ok...wires to compressor ok..when i went to the pressure sensor to make sure its not loose i damaged the connector on thr receiver drier..now pressure sensor is disconnected but to my suprise ac clutch is engaging!!! How is tht possible? As i knw the clutch will not engage when the pressure sensor is disconnected

Don’t u have to take all Freon out first ???

Why are both radiator fans running!? Even with ac off and heater, already replaced temp sensor and nothing, No car is not overheating.

Hello I have a question for you. my wife have a 2011 nissan maxima and the compressor won't engage. it was blowing real cold. I did notice my kids keep opening and closing the rear vents playing with it. and the all of a sudden the a/c compressor shut just shut off. what do you think happened. and where do I start. and what do I check for first. my wife is getting on my nerves thank you sir.

Y my car won't take refrigerant it only takes like 1/4 of a can crompressor sims to be working ok .thanks wait for and answer i forgot the car is a 98 Nissan maxima

I have a 2009 Nissan Altima hybrid that ac dos nothing but blow hot air

Changed mine and now leaking from one of the lines that connects to it

i have a problem with the ac that when I turn on the ac on the car the compressor work directly but the cold air works for 3 to 5 min then the AC turns off and starts blowing just air, I turned off and start again, for 2 min blows ac and then just air, can somebody help me with this problem, thanks in advance