Quick and easy video to help you wire your generic light bar harness properly. www.tericksolutions.com
Пікірлер: 10
@mdcarlson_8043927 күн бұрын
I used your video today to wire two Rough Country LED light bars each of which came with their own harness that included a relay but was designed to connect directly to the battery terminals. I wanted to connect each to the Polaris Pulse accessory bar and take advantage of the switched power to avoid battery drain. I removed the ring terminals from the positive and negative leads from each wiring harness and connected them with butt connectors to the red and black wires of Pulse bar pigtails. I then followed your instructions to remove the control wire from the relay where it was connected and reconnected it with a butt connector to the blue wire on the pigtail. After ensuring that everything worked as desired I heated the heat shrink tubing over the butt connectors and zip tied all the extra wire from the harness. I also added some labels to help me keep things straight as I add more accessories. Thanks for the great tips and easy to follow video!
@waketyme6 ай бұрын
Thanks for this video! I've been trying to figure out how to jumper to just accessory power for my ranger!
@christophermckoy367110 ай бұрын
Thank you
@lenmoralesjr10 ай бұрын
I wish you could show the back of the switch for reference.
@mastando747 ай бұрын
I installed the wiring kit from niteliite, was prewired basically plug n play, so now I have constant power to the rocker switch and the light on the bottom of the rocker stays lit constantly, ita suppose to go on n off with the key. I have switched the wires around every way possible on the back of the rocker switch to try n get it to work with the key on but no luck. The directions said for the key on was to jump the red wire to the #6 on the back of the switch but that just gives it constant power to illuminate the bottom part of the switch. What could possible be wrong here?
@martythornton6043 ай бұрын
Are you connecting your fuse to the pos battery and the modified switch wire to your key? Also, what wires hook to the 5 pin switch?
@NewLife-qj9mx4 ай бұрын
Great video, thank you 🙂 This worked great, except ☝️ Im trying to hook up 2 switches - front light/back light. My problem is both switches turn on both lights. Im pretty sure its how the switch bank is jumped together but idk. Any ideas? I have 2 switches just like the type you show here (should there be a disclaimer on this video "for single switch only!" ?)
@davide3129 Жыл бұрын
I don’t understand why a 10am fuse gets blown on a 2amp light bar??
@tericksolutions6419 Жыл бұрын
I'm guessing if you blew the fuse something is not wired correctly
@jonathanbeltran71767 ай бұрын
I want to add my whips and chase bar to my turn signal kit. So do I solder cables after the relay?