Shows how to adjust pull compensation on lettering in Floriani Embroidery Software.
Пікірлер: 4
@forthefamblog10 жыл бұрын
I so appreciate your matter of fact explaining of this floriani software lettering pro III. Your voice is pleasant to listen to and I only regret that I don't have you going through the whole thing! But thank you for the ones you did do. :)
@pandahugs94997 жыл бұрын
Thank you for this explanation about pull compensation. I own a Brother PE770 and I have issues my finished result. I have an egg shape object with a black outline that is touching the egg shape. However, when I run it through and it embroiders, there is a gap between the egg shape and the black outline, whereas, on the software it shows no gaps at all. Will increasing the pull compensation help my issue? I'm using Floriani Total Control U. Also, I use tear away stabilizer on the bottom and a water solvent one on top. Thanks! Hope to hear from you soon!
@sandiesepulveda73518 жыл бұрын
Great video. I do a lot of bath towels and semi- thin kitchen towels , I just did a split lettering on a bath towel came out ok, but it seem to be just a little sunk in. what would be your % recommendations on these.
@Nannajb110 жыл бұрын
If a letter is tall and thinner how do you make the whole letter wider than it is? Judy