Rebuilding your carbs and don' have expesive fancy tool? This is the best way I'vefound to do it and get them close.
Пікірлер: 10
@hueyhoolihan582 Жыл бұрын
ya, pretty much how i synced the dual carbs on my 2003 yamaha 1100. i would hold them up to the sun as i was usually working outside and didn't have access to electricity.
@haidensmith74733 ай бұрын
Thank you! Buying a 1984 kz550 and wasn’t sure to sync the carbs
@mikeberesford49558 ай бұрын
Nice job 👍,thanks!
@AdventureBrad8 ай бұрын
Hope it helps!
@jerryeinstandig79965 ай бұрын
i dont think your method is very accurate. i line up each throttle plate to just begin to expose the first progression hole. its important to snap the linkage a couple times anytime a screw is adjusted to let things settle into place.
@macandcheese47894 ай бұрын
I have a Suzuki marauder 800 and it won't go past 70 when I give it full throttle it jerk's and snaps
@papercut19872 ай бұрын
perhaps your main jet is clogged?
@hydron1397 Жыл бұрын
would a feeler gague work in there too?
@AdventureBrad Жыл бұрын
maybe thin wire?
@jerryeinstandig79965 ай бұрын
not so well as the feeler is flat but the carb is round