AFTER YOU HAVE CROSSOVER YOUR TOPS AND SUBS SPEAKERS, SEE THE PROBLEM.
Рет қаралды 2,285
3 ай бұрынThis video is to educate you on how after crossing over your drivers, you loose some energy at the crossover region. am using the measurement software call smaart to demonstrate for you to see how critical it is.
am all about given you little tricks to live sound.
subscribe to my channel.
@kali852 3 ай бұрын
gr8 video ✅
@samuelkennethacquah1068 3 ай бұрын
Thanks sir
@shangomensy7403 3 ай бұрын
Hello please How do you route reaper signal on Smaart or Smaart to Reaper?
@samuelkennethacquah1068 3 ай бұрын
Hello! You can do that by using two computers and two audio interface. But if you have only one am sure what am going to say will be understandable for you. Smaart have two out for sending signal out. I used only 1 output from smaart, and in Reaper I activated the input to listen to the input of the reference signal. After I send only 1 mono signal from reaper to my audio interface output. Remember I used only 1 output from smaart. So the output of reapers comes in as my measurements microphone that's is input one. I no is confusing, but that's how I did it.
@isgaming3.089 Ай бұрын
Hey can you make a video doing connection and set software
@samuelkennethacquah1068 Ай бұрын
Please about which connection
@isgaming3.089 Ай бұрын
@@samuelkennethacquah1068 like how to connect your mixer to your audio interface and then to your PA system how to set up your software
@samuelkennethacquah1068 Ай бұрын
Okay sir I will look into that
@isgaming3.089 Ай бұрын
@@samuelkennethacquah1068 really appreciated waiting for your video ❤️
@marioedwinperalta6078 Ай бұрын
Yes please
Jay's iyagi
Рет қаралды 53 М.
Michael Curtis
Рет қаралды 75 М.
Руслан Мирошниченко
Рет қаралды 4,6 М.
HD MOVIE SOURCE
Рет қаралды 5 М.
Audio University
Рет қаралды 556 М.