Do you know the right one for Nissan?

@@isaacnewton1545 From what I can see it looks like 2.2 ohms will work for Nissan as well. If you search “NRG 2 ohm resistor” or”NRG airbag bypass” they sell what looks like a fuse with 2 red wires. That is the one I used. It’s around $10-15 for a 2 pack usually.

@@CouchMan88 thanks for the reply. Also do we need especial tools to remove the plastic on steering wheel to have access those airbags fuses?

@@isaacnewton1545 The fuses should just be normal fuses. Make sure to disconnect the battery for at least 20-30 minutes before working on anything related to the airbags. You don't want them to go off while doing anything with them. You need to look up the procedure on how to do it for your car. There is a potential for an airbag deployment, so you need to be really careful and understand the wiring diagram. Much of the time you can just pop off the plastic, remove the bolts/nuts that hold the steering wheel on and unplug the harness to it. Always make sure the battery is fully disconnected. What you need to do is find what two pins on the airbag wiring to connect with the resistor to and then it will prevent the airbag light from coming on. You can also just leave it unplugged and remove the fuse but it will illuminate the SRS or airbag light on the gauge cluster. Keep in mind removing the airbag in most states is not recommended and many times illegal. All the bypass really does is prevent the warning light on the dash and keep the passenger airbag functional if you remove the one on the steering wheel.

For vw golf 5 airbag pasager?

Yeah, fiddling with airbags and getting a fright are a great combination.

Lol busted out laughing when he did that

Hahaha

That's good to know as I've just invested an a Launch diagnostic tool. There should even be a couple of videos, eventually.

@@DavidMcLuckie there good little units i even found codes in my old van that wouldnt read on the works scanner.

Crocs all the way.

The code reader I have only does the engine ECU, currently waiting on one coming from Wish to try.

@@DavidMcLuckie pp2000 is I think the kinda thing your looking fot.

works with any car......

Do you think it will set it off?

Que dijo jajajjjajajja

Como puedo pedirlas, es una resistencia pero qué características para poder conseguirla xfa

While I waited for the scanner to arrive I had unplugged and replugged all the airbags. It said it was a fault with both fronts. But it cleared and didn't come back. Might have been something like a battery voltage issue.

It wouldn't be a real Citroen without some kind of electrical gremlin.

@@DavidMcLuckie Ive got the same car ( Toyota Aygo ) with the same fault , cant seem to find any damage to cables , Has yours still cleared ?