Allis Chalmers WD 45 Tractor and John Deere Disk

Рет қаралды 13,253

Roger Miller

Жыл бұрын

Disking corn stalks in preparation for plow day with an Allis Chalmers WD 45 tractor

Пікірлер: 18

@HumbleHaymakers Жыл бұрын

Excellent video - WD45 looks good and sounds good.

@donvoll2580 Жыл бұрын

Good day from Ontario. Yes that hand clutch was very handy, going thur gate push hand cluthe forward , way u go. Thanks

@wcox4 Жыл бұрын

Makes me miss my set of KBA's.

@aliciabrowndocken4660 9 ай бұрын

Traction Booster works by slightly raising the 3 Point mounted implemented such as a 3 or 4 bottom Plow. That reduces the Drag and transfers more weight to the rear wheels helping to reduce wheel spin. We had a WD45 Row Crop front end tractor with a gas engine and it pulled a 3 bottom Plow. Our WD45 Wide Front end had a Diesel engine and it pulled a 4 Bottom Plow. When plowing in the Spring it the ground was very wet that Traction Booster would be working it's Ass off. It only raised the Plow a couple of inches but it really helped. Riding the turning brake on the wheel with the least Traction helped a lot also. On our tractors the Traction Booster wasn't activated at all unless the Hydraulics were in the down position. It's only job is to raise the 2 lift arms slightly. Only works on Mounted Implements. 5:11

@rogermiller7411 9 ай бұрын

Thanks for the advice. Looking forward to to plowing next spring and learning how to use the traction booster.

@davejohnson2937 Жыл бұрын

i got a ac wd45 and same disk is a good combo..

@scottmattingly9643 Жыл бұрын

Nice very nice 😊

@huckstirred7112 Жыл бұрын

put 500 pounds on that disk really helps

@rogermiller7411 Жыл бұрын

I’ll try that. Thanks.

@aaronfarr4753 5 ай бұрын

Never use the foot clutch it’s not necessary except when shifting the pto into gear or when using the belt pulley for stationary work, it’s only a single dry plate and you’ll wear it out and wish you had never put your foot on it even once when you have to pull the motor to put a new one in. Learn to use the hand clutch and love it because it’s the actual main clutch and is a multi plate running in and oil bath and can be slipped all day and never wear out. Using the foot clutch to start out pulling a load like that is a sure fire way to lead you to hours of hard labor,skinned knuckles and a lot of cussing that all could have been prevented by not using it.

@danvanhoose6783 Жыл бұрын

Disk needs some weight.not doing much.

@jvin248 Жыл бұрын

Or open up the disk angle X more.

@rogermiller7411 Жыл бұрын

Just trying to cut stalks. Not sure how to add weight - there are no rails on top of the gangs like an IH disk to hold the weights in place.

@rogermiller7411 Жыл бұрын

I believe it was set to cut at the sharpest angle.

@frankwurth5375 Жыл бұрын

I wouldn't add much weight, those old disk journals wear out fast enough without help. Newer ones use sealed bearings and are considerably more durable.

@stopthemadness398 Жыл бұрын

why di American talk almost 70% of the videos away... why not less talk and more action????

@aaronfarr4753 5 ай бұрын

Especially when they are talking about something they actually know very little about. Hearing the words I think in a video like this makes me cringe and would have made my dad slap the narrator while screaming don’t think, know GD it, now go read the GD manual and don’t even think about touching it again until you know how everything works and the safe and proper way to operate it! My dad may have been rough and stubborn and kind of an ass but when he taught us something the lesson took, we never got hurt by equipment, we never broke anything that could’ve been prevented and from hand tools to bulldozers and everything in between, you can damn sure bet we knew everything possible about each piece of equipment before we even thought about using it.

@stopthemadness398 Жыл бұрын

sorry but i did not come to watch people talk on their videos.. i only SUBSCRIBE to video with more action and less talk.. don't care to hear people voices.