Ingredients: 1x Arduino Uno 1x Breadboard 1x Chopping Board 1x 6 DOF Robotic Arm Kit 6x MG996R Servos 6x 20k Potentiometers A bunch of jumper wires Code and Circuit Diagram: drive.google.c... Music by Labile Music / @labilemusic
Пікірлер: 23
@rezanikzad1227 Жыл бұрын
Wow 👏
@RISHIPATEL-fo6mk2 ай бұрын
You should add record and play feature.
@vishalvishal-bw5thАй бұрын
NO
@MrBalkanx3Mix Жыл бұрын
Awesome!
@OOPMAHS4 ай бұрын
Have same arm but the base servo cant handle all the weight of arm
@tanakachidemo4 күн бұрын
Got this issue too. Do I just have bad poor quality servos or I need a different spec
@shijumax110 ай бұрын
Good job kit vought drom ebay?
@mujaddadsadiq44945 ай бұрын
Hello, I can’t access the code for this 6-DOF Robot Arm. Please check it again or upload again, Thank you
@RaspduinoUno4 ай бұрын
Apologies for the slow reply, could you please check again? The link seems to be working fine. You need the Arduino IDE to open the INO file to see the code. Cheers!
@benjiedelavega5175 Жыл бұрын
how can i get the code sir?
@GamingOdyssey010 ай бұрын
its in the description
@ankitmehta1089 ай бұрын
ingredients link
@itsmoha4067 ай бұрын
Can we replace server motor with sg90 ?!!!!
@RaspduinoUno7 ай бұрын
You would need to make a smaller scale arm with lighter materials if you wanna use sg90 😁
@aatiftazwar69027 ай бұрын
Hi what material/part did you connect to the potentiometers to make the controller arm?
@aatiftazwar69027 ай бұрын
at 2:00?
@RaspduinoUno7 ай бұрын
I used plastic which i cut out from an old file
@raguoffical77266 ай бұрын
that 6 servos comes with kit?
@RaspduinoUno6 ай бұрын
Nope, I had to buy them separately for my case
@giliardpaz58966 ай бұрын
Excellent job. But I can't open the code, it gives me an error, can you help me?
@RaspduinoUno6 ай бұрын
Thank you! Could you elaborate further on your problem?
@giliardpaz58966 ай бұрын
When clicking on the file it gives this error: Unable to create sketch@@RaspduinoUno
@RaspduinoUno6 ай бұрын
@@giliardpaz5896 Perhaps you can copy the code from the ino file by changing the format to .txt and then pasting it on a new sketch?