Truly helpful since I’m actively looking at both. Thanks for the info.

Thanks for doing such a great job! The way reviews are supposed to be done. Present the facts, and pros & cons for different uses.

Thanks for the video. I'm ordering the Atlas. Cheers.

hi john, great job. as a parking lifts suppliers, i have to say all the two lifts were from China. that why it is hard for them to control the painting quality,and so on. about the weight capacity, nearly similar, cause all of them use 5mm thickness plate as runways. very surprised about their price. cause in China, only around US$1200. the sea freight is about $200. the related cost in your sea port is about $500 maxim think. find a truck to pick it to your home. it is easier to install by yourself.

I’d like to see u go to a couple of buddies houses and give a review on more brands of 4-post lifts.

I have a new poured 6 inch thick 4000 psi concrete floor...should be fine as manufacturers mention only need 4 inch slab

I've been planning on getting a lift for a couple of years and after reading all I could, I would stick with Advantage lifts. Vastly superior materials quality and safety design. A but more than these, but you get your money's worth!

Is one made here and one in china.

Firstly, to PROPERLY bolt either one down the stanchions must be anchored into a piling cap with a depth no less than 12" for proper structural support. It's these lil DETAILS that folks do not take into consideration cause most garage floor pads are 4" of concrete and are NOT Structurally rated. Afixing a lift on this surface is simply a disaster waiting to happen. For instance, Cracked floors (weakening the area entirely), these cracks can splinter all the way into the foundational footer and your beautiful home is now an expensive structural repair disaster. AND the bottom of the stanchion supports are supposed to extend out encompassing the entire underside as a BASE Column Fix point. The entire column support and base support can be poured at one time, allowed to cure for three days before patching the floor and maybe epoxying the floor but full structural strength is not achieved for 30 days. And the entire column must be reinforced with rebar steel embedded in it.