A really easy to follow repair video, thank you for taking the trouble.

Very good video! How do you set the dash to test mode? I just see you turning on a external power supply and the dash is in test mode. Is there a separat pin on the dash connectors to supply with 12VDC for test mode?

Thanks for video and spare part supply. My 2001 A3 8L fuel gauge is working well again.

ive had trouble with my temp gauge,you have cleared this up for me brill video excellent instructions ill be ordering a s a p mant many thanks

Hi I have a Audi TT mk2 8j haven a issue with temp readings it’s not moving

@akspeedo I replaced my dash and now it reads reversed do you know how I can fix this?

En mi caso resulto ser el enchufe del sensor de temperatura, no hacian contacto todos los cables, asi que torci un poco los pines del sensor de temperatura y quedo funcionando bien, tuve muchos problemas, habia cambiado practicamente todo

Is it a possibility if I take my cluster out, to repair both the temp and fuel gauges that my key won’t work to turn my car back on? I had a 2008 Audi A3 which I needed to replace a ignition switch and barrel, once i did I had triggered immobilizer and my car never turned on again without needing the dealer to re program my key. So I’m afraid of repairing these little motors and my 2004 3.2 v6 TT not turning on again without having the dealership program my key.

@akspeedo how can i order the temp and fuel motors for audi tt 1999 i've been to your website but i don't know witch one should i ad to card 🙏🙏 thank you for the vidéo ✌

Are still repairing insturment clusters? If you are, can you repair a cluster off a BMW motorcycle 2005. R1200GS. The speedometer & tachometer are not working. Thanks. Robert

Hi! Thanks for the video! I replaced the fuel gauge motor and put the needle to "full" (while ignition is on) since the tank of my car is currently full . When I switch the ignition off, the needle does not go back to "empty" but stays somewhere just below "half". When I switch the ignition on again, the needle goes to "full" again. Do you have an idea what the problem could be?

You opened it up, why not replace the FIS LCD?

My temp needle jumps around, a cold car will start at 90 degrees then while idling the needle goes to 130 and then while driving it will suddenly drop to 50 hitting the dash sometimes puts the needle close to 90 . Temp in the AC screen (code 49) corresponds with the needle, when temp gauge is "overheating" AC temp reading says 122 degrees, when temp needle is at 50 AC reading says -10. Is this the pointer motor thats faulty or?

Hello there great video I must say. Slight problem I have is when I bought the car my traction control light wouldn't come on. I've done a search with VAGCOM and no issues. Tried a different speedo and light comes on. My question is how do i get to the bulb or display to see if it's been covered in the past?

i have 2000 audi tt that fuel gauge doesnt work. i used my scanner to read fault codes in the DashBoard and it gave me a code 00771 fuel level sensor (G) short circuit to earth. does that mean the fuel gauge motor is bad? do you think changing the little motor of the fuel gauge is the fix for the short to earth.? thanks a lot for your videos.

How i can order these 2 pointer motors? Do you have any link?

Why was it still flashing up coolant level low on the centre screen

Why not use VCDS and set the tank sensor higher like on 135. A lot easier

0:40 and 8:05 looks very much like the fuel and temp needle illumination is out as well? You really should have reflowed the resistor on the other side of the board (immediately above and top centre of the LCD glass) while you were in there.