Axial Ryft Rock Bouncer Tube Chassis 2 of 2

No video

Axial Ryft Rock Bouncer Tube Chassis 2 of 2

Рет қаралды 309

Жыл бұрын

Second run of my Ryft Rock Bouncer chassis after replacing the driveshaft pin that came out of the front driveshaft. My son is driving on this one. As stated on my first video of this chassis I would pass down the savings of making these on to you guys if I was able to go through my first batch and I did so thank you so much! Now, I was able to put in a bigger order and in doing so the price went down per unit. Right now the price is set at $250 instead of $300 which is what it started at. Thanks again for your support and I am really looking forward to bringing more designs at an affordable price!

Пікірлер: 8

@krashkingrc9715 Жыл бұрын

Awesome looking rig great build

@Gamyrc Жыл бұрын

Thank you!👍

@paulschryer9571 Жыл бұрын

- I lost a pin too !! But the pin I lost was in the (12mm Hex) area, for the wheel !!! ...And I did the same thing, cut off about 11mm (to fit inside the 12mm Hex), and it fit "tighter & better" than the stock roll- pins/"Hex-Pins" !!! 👌I believe the drill-bit piece I put in, is way stronger than the stock roll-pins, as well !!!! 💪👍 I might do the same to all four corners, but at least my new "roll-pin" is in the driver's side front !! 😉 Great idea you & I had !!! ✌️ ...Very nice chassis/cage !!!! 🤘😜👌

@Gamyrc Жыл бұрын

Yes, I do feel it would be much stronger. Great minds think alike 😉😁

@hellbillywv5724 10 ай бұрын

I've seen the really cool SCX24 chassis you've done, really cool. I have a Ryft and love it. I bought my nephew a UTB18 and he loves it. But he really wants to bounce it. I'm trying to figure out how to get it lower and much faster. Have you done anything with the UTB18?

@Gamyrc 10 ай бұрын

The Furitek Bettle chassis for the UTB18 is my design. You could try that one. I have a couple more designs but we aren't ready to put those out yet. It takes a while to fully test them to make sure they perform as good as possible 👍.