Cool tune, excellent work bro!)🥰🤩💥💯👍👏

Great video guys the scx6 is a beast... Can't wait to see who wins that sweet giveaway truck..👍💯👊

One day soon I will pick up mine.😎 at least you saved me finding it out my self 🙏 awesome my friend.

I was just doing work on my new SCX6 and found the ring had a wobble to it when turned that would cause it to be too loose at one point and way too tight 180 degrees around on the opposite side. I thought maybe it was faulty or bent somehow. Couldn't see how it could bend though. I ordered a new ring and pinion set and installed it. The wobble was even worse. It took a bit of cursing and investigating and what I finally found is that with no screws in the ring gear it would not sit flat on the inner "carrier". No matter what position I put the ring gear on the inner part it would rock side to side as I pushed down on it with my fingers. I checked the carrier and it spun and ran true so it was not the hub part. Where the fault was on both the original ring gear and the new ring gear was the inner diameter was a sharp 90 degree edge and this was hanging up on the inner surface of the carrier part. I used a 3/4" grinding tip for a drill (similar to a Dremel 941 grinding tip but larger) to chamfer the inner diameter of the hole in the ring gear where it seats on the hub. It didn't take much, such a small amount that it is hard to see the chamfer. Now it seats flat onto the hub and spins true in the differential with no wobble. As it turns out I didn't need a new ring and pinion I just needed to fix the problem. Now it is back in and shimmed with no play and no binding. Just a heads up for others that may run into this issue.

Can’t wait to see who that lucky winner is

just got me a SCX6, the only thing i dont like is that the diffs are all locked, i wish the front was at least open diff or manual diff. not all fully locked

Going to have to do this to mine, thanks for the great video!!

Informative video, thank you. 👍✌️

Wishing you guys the very best for 2022 Cheers 👍

Nice info brother 👍 il check mine wen I get it in 2 days time. Awesome video buddy an give away 😀 🇬🇧 👍

Just drove mine for the first time today. The front is clicking from time to time. Hopefully I'll be able to just shim it.

Is that the same oil or grease in the transmission I'm trying to regrease my transmission but all I have is dynamite marine grease can I use that or do I need special oil or grease for the scx6 transmission????

Thanks for the how to video. What would cause the front end to shake under full steer? would it be an axle starting to go bad.

Is shimming the scx6 jeep going to be the same when shimming the scx6 honcho? Thanks

Why clean out the factory grease and reassemble with none? That makes no sense...

Canada…

Metal housings don't do that and is a huge recommendation. Plastic gets warn out and breaks to fast. Witch makes it unreliable in the long run. One roll the right angle and its broken just saying. Just saying not everyone wants to carry it let alone far lol.

In the state of commieforna everything causes cancer lol. Worst state in the country. Best landscapes worst for freedom. But thanks for the video. Have used your tips many times for things. I just got this truck so will probably have to do this.

Zuviel Reklames, schade