Bambu Released PVA Support Material! | Water Soluble Supports!

No video

Bambu Released PVA Support Material! | Water Soluble Supports!

Рет қаралды 4,615

3 ай бұрын

In this video I perform a few experiments with Bambulab's PVA support material. This material is water soluble, and makes it easy to remove supports. It's expensive, but there are definitely uses for it. Watch and experience first hand what this stuff can be used for!

Пікірлер: 16

@Beehive66 12 күн бұрын

PVA in China is like...USD 5 dollars a roll. Not sure on the quality but he, it's just for supports. Thank you for your video. Useful.

@thebatlwgn 3 ай бұрын

Dude, thank you for this video. I printed a skull that has celtic markings all over it using the "support for PLA" product and it was awful. Its still stuck in all the small gaps even after using tons of force to get it off. Just not a good experience there. So I bought some PVA to try for a reprint. Glad to see it worked out here.

@PrintPractical 3 ай бұрын

When you get the PVA, just be patient and let the water do its job. This stuff is sweet for use cases like that.

@whitetailtherapy7908 9 күн бұрын

What was your purge volume? Iv always had trouble with the support material still being in the nozzle and contaminating my print

@rylan2024 9 күн бұрын

How do you switch between different materials within the support?

@ChippWalters 22 күн бұрын

Thanks for the video. By the way, that rook should print just fine without support.

@NoMercyFtw 3 ай бұрын

LOL the resin printer ROOK

@oscarx6384 2 ай бұрын

good video thanks

@noobt4eguns 3 ай бұрын

I ordered TPU and i wait them Until now i print pla,pla with silver powder and pla plus. The pla with silver powder its the most strong from the others pla

@felipeduarte_id 28 күн бұрын

which 3d printer did you use?

@PrintPractical 28 күн бұрын

Bambu P1S w/ AMS

@felipeduarte_id 28 күн бұрын

@@PrintPractical thank you! I heard the TPU can get clogged in the AMS and I was wondering if PVA too.

@PrintPractical 28 күн бұрын

PVA works fine, but you have to make sure it’s very dry. TPU is not recommended nor have i tried it, but I don’t think it’s a good idea. The path that the filament takes to the extruder is so long, with multiple motors pulling the filament through. It’s going to be hard to get consistent results when the filament stretches so much.