No video
Bambulab A1 vase mode test
Рет қаралды 2,137
Күн бұрынA follow on video from the transparent rocket printed from petg - it was printed in standard mode with a visible seam on the rear and an audible clicking at each layer change
This one is printed in vase mode from PLA
If there is anything you would like to see tested or printed on the A1 or a suggestion as to what changes to make to improve a print drop a comment below i will do my best to respond to all comments
@mnedez5826 7 ай бұрын
Hi, Hello, how did you change the extruder wheel? Thanks!
@Kenprints 7 ай бұрын
you just pop off the front cover and pull the wheel off and replace with your own printed version
@mnedez5826 7 ай бұрын
I'm new to this and I was afraid to throw it and break it haha, thank you very much for writing to me and have a happy new year
@Kenprints 7 ай бұрын
@mnedez5826 no problem if you want assistance making one let me know 😉 happy new year
@GoldFus1on 7 ай бұрын
Narrow tall objects use glue?
@Kenprints 7 ай бұрын
i use the bambu liquid glue mainly because the room the printer is in isnt very warm and tends to have drafts so its extra peace of mind while it prints i dont think its essential though it seems to put down lovely consistent layers
@GoldFus1on 7 ай бұрын
@@Kenprints do you clean the build plate between prints?
@Kenprints 7 ай бұрын
@GoldFus1on nope