A simple guide for beginners to configure a Cisco Catalyst Gigabit managed switch for home or office. You only need a laptop or PC, no extra software needed. Im using a 2960S.
Пікірлер: 12
@lordmemester879813 күн бұрын
Thank you! I now have a working Ethernet switch :)
@OnTVaustralia2 жыл бұрын
Hi Photon, thanks for sharing. This is my project I'm working on today, and am curious if you think mounting on its side would cause any issues. I'm mounting it vertically on a wall with the ports facing off to the right.
@photon44072 жыл бұрын
That sounds fine. You just don’t want to block the rear (outlet) and side (inlet) vents. Enjoy your project!
@bhimanenivenkatesh2840 Жыл бұрын
Thanku sir I have one dout my office systems connect to Cisco catalyst 3960 poe switch Problem is when I power on the computer network connection up in take 2 mints time Can u please tell me sir System network connection up on very fast
@One-Crazy-Cat3 жыл бұрын
Any pointers on the fan mod?
@TechandTravelWheels2 жыл бұрын
just remove it! As long as you are using it withing the room temp, it works fine without I have been using it over 2 years already and no issues so far...
@itelementum49382 жыл бұрын
Sank you. Best video.
@photon44072 жыл бұрын
Glad you liked the vid.
@gavinlo4785 Жыл бұрын
Can you have the 2960-s manage DHCP or is it best to leave that to the ISP router?
@photon4407 Жыл бұрын
You can, but I always use a separate router. Ideally you want a separate modem, router and switch as the all in one devices are rubbish.
@JoshuaFangNZ3 жыл бұрын
Thanks for this! i have the exact model - sorry i'm a complete newbie to networking - just need it to work!. i followed your exact instructions including IP addresses on the quick set up - after doing that - the switch works fine, but i can't access the quick set up url again which is default 10.0.0.1 ... any idea how to access that again? Thanks.
@photon44073 жыл бұрын
I changed the IP during setup from 10.0.0.1 to 192.168.1.11 Type in 192.168.1.11 and the Express Setup is available in the Contents menu under Configure.