Basic Tools Required for Electronic PCB Repairs

Рет қаралды 33,210

1929fordhotrod

Күн бұрын

This is a short video and explanation of the very basic and inexpensive set of tools required to do simple printed circuit board (pcb) repairs for the Engineer, Technologist, Technician, Tradesperson, or Hobbyist.
I will post additional videos on soldering, electronic assembly, and basic printed circuit board repairs.
Below is the basic and inexpensive tool list:
25w to 40w soldering iron with pencil point and chisel tips (35w would be the best choice for the first time user)
Soldering iron holder
Sponge for cleaning the soldering iron tip
60/40 flux core solder 0.8mm (0.032”)
Solder sucker/extractor/pull
Solder wick 0.1”
Rubbing Alcohol 90% or better used to clean flux off printed circuit boards
Tooth brush
Electrical tape CSA or ULC approved
Small roll of masking tape to hold small parts on the printed circuit board while soldering
Stand to hold small printed circuit boards
Magnifying glass
Fine steel wool (0000)
Plumbing acid flux - Home Hardware #1139-209L Masters Solder Paste 57g Cat No. SP057C or Kester Acid Paste Flux SP-30 50g. This will be used to help clean the soldering iron tips and will never be used on a printed circuit board as it is corrosive.
Stainless steel scouring pad
Small set of jewellers’ screwdrivers both slotted and Philips
Small side cutters
Small needle nose pliers
Wire stripper
Tweezers

Пікірлер: 18

@gerryquinn8390 6 жыл бұрын

Thank you, this is not only very helpful and informative but is put in a way that 'normal' folk can understand and afford.

@paulrowland4857 8 жыл бұрын

Thanks for the effort in putting this together! Very informative!

@khanshahzad77 4 жыл бұрын

thank you so much for nice information may god bless you

@Sarikatour 3 жыл бұрын

very helping

@bobbyberetta4206 9 жыл бұрын

Great info, thank you

@rosskrause3926 6 жыл бұрын

i live right by farm rd 1836.

@zilicao2686 6 жыл бұрын

Very informative!

@davidgaleski5303 8 жыл бұрын

thank you

@matthewp3709 6 жыл бұрын

No DMM? Informative video with humor sprinkled in. Thanks!

@Toxicaligator 5 жыл бұрын

You forgot to mention the wire strippers mounted in ones mouth

@jatinsbhatt 6 жыл бұрын

Nice for knowledge

@SilverMoonJoe 8 жыл бұрын

Very informative and simple. Thanks for sharing... 73, Joe-k4jga

@anurajayalath7093 6 жыл бұрын

actually it is very helpfull .. thank you

@kamranansari2245 3 жыл бұрын

What's the backwash

@johnnydrone8547 8 жыл бұрын

Thank you... Very useful! Is there a tool to score the circuit board lead to allow the solder to stick better?

@1929fordhotrod 8 жыл бұрын

+johnny drone - never score electronic parts or the circuit board. If the pcb will not accept solder, the pcb needs to be cleaned with rubbing alcohol. Same would be true for electronic parts.