Nice vids Gav. I’m in Vic. Just bought SX82 today (Edisons AU$154) and picked up a side cover, fuel hose, spare exhaust from Farmertec in China. $60 shipped (parts about $25) Noticed that Johno & Jono stock Hsky parts in Aus too. Thanks for all the tips mate 🇦🇺

You can also use the dogs at the front too and get 2 instead of 1 supplied, gives you much better control of the cut and keeps it further away from the wood

Thanks a lot mate for putting this up, I'm going to husqvana to change out my bar and chain from a 24 inch to a 20 inch and change that side cover to something more reliable.

I have a Greencut GS7200 which is basically a Husqvarna 365. It even has this cast into the crankcase. I have a tip which might help. I found that the pin that holds the throttle trigger comes out over time making the throttle stick. My solution was to put a little hot melt glue on each side of the pin. It stops it working loose but when you need to take it out the glue will break off easily with a flat screwdriver. Also I read somewhere that these saws are made in the same factory as the Husqvarna but during the night shift when normal production stops. I think they're top quality & when I need parts I'll just get Husqvarna parts as the people who sold mine have no idea about after sales & parts. Amendment : the hot melt glues melts with the heat from the chainsaw. I shall try Araldite instead.

FYI Dolmar do exist, they're Makitas now

Gavin i'm an old time dealer and you need to smarten up on a few phases I know and understand you received no formal training in chain saw servicing so let me help a tad now i'm not being a smart ass or anything but first up chain selection I see your using super chisel a chain meant for professional use in green timber not old dry firewood a semi chisel chain would be better it will have more endurance and hold it's cutting edge better in dry hard timber. Super chisel requires a keen edge and more precise angles that's why its better on green clean timber. If you can next time the bar adjuster fails try your huskie dealer for a replacement I see when I visited the Edisions site some assy's are cheaper than buying the screw and bar adjustment tang. I don't know who schooled you but I was taught to assemble the bar and chain onto the saw with the saw powerhead sitting on a bench and not upside down like in your video. I sit the saw in front of me and fit the chain into the floating rim then the bar making sure all will rotate and then I back the adjuster rearwards to give the tang a bit more room to pick up and engage the slot ..... now you will find the side / cover over the clutch will engage easier and then pushing the cover In adjust the chain tension whilst holding the bar tip up snug the bar nuts and all's sweet. The sprocket nose allows you to add a bit more tension on the chain but overtightening the chain will lead to the chain stretching and more adjustment. Now when the chain does need adjustment let the saw cool as adjusting a hot chain is not a smart move as it stretches the chain let them cool then adjust. Just hold the tip up and adjust the screw and all should be sweet.

Is the MTM 72sx the same? Husqy bar and chain?

the old 92cc had 3 ports

Hi have you tried to replace the bar studs. One of mine broke and can't get get it to unscrew, moves 1/8 turn either way and jams

👍

Can you use a Husky chain tensioner on these Baumr's?

Are all parts the same as husky? Pull start, fuel lids etc?