ingenious method for forming aluminum rigs!

очень понравились ваши видео . приятно посмотреть как вы профессионально работаете. аж слюни текут

You need tin bashers players. Very good videos I would not think of using rubber for your press. You are right about the jack.

Why not route the form back 13 degrees so that the ribs spring back to 90 from the hammering?

I would have thought that this kind of treatment is quite likely to work harden the flanges, compared to fewer blows with a mallet.

Wondering if you could have used the press instead like you did with the internal holes?

I am also wondering why you could not use the press to flange these ribs as you did on the nose ribs? Can you answer please? Thanks, Steve with Patrol scratch build #310.

I'm curious why you didn't form the flange and the lightening holes at the same time.

Dear Friend what you shared solved a problem that it was about two years I was involved with it,thanks you very very much for your great help.I have one question:up to what thinkness steel sheet can get formed in pas forming? is it functional for 1mm thickness metal sheet or its usefull just to very very think sheets? my warm greetings to you from Iran.

What is the status of this build? Did you complete it?

You can also get that tool here for $25. www.aircraft-tool.com/shop/detail.aspx?PRODUCT_ID=ATS107A-7N

By doing this type of rib's forming, you have fucked up with aerodynamic performance of rib's skeleton........lol

Why not route the form back 13 degrees so that the ribs spring back to 90 from the hammering?