Ben's Workshop Journey #81 (Completing marking out and starting to cut mortices)
Рет қаралды 303
4 ай бұрынI finish the marking of where I need to cut the mortices and then the long job of actually cutting them.
Unfortunately, my plans are scuppered by a failure of the machinery)
@MakerBoyOldBoy 3 ай бұрын
Again, Ben details the many small bits that have to be so carefully laid out before assembly can begin. Not exciting nor dramatic, but critically essential. Other channels leave out these bits. This is precisely how projects are slowly built. Lack of patience at this point leads to project redoing that never seems to end. Gaz
@benelliott8745 3 ай бұрын
Thanks, Gary. I'm learning slowly 😄
@TimPiggott 3 ай бұрын
I have spring pins and parallel punches if that helps!
Ben Elliott
Рет қаралды 238
Kirill Multitool
Рет қаралды 72 МЛН
Ben Elliott
Рет қаралды 277