BF MP7 Nozzle/T-piece sealing Issue (V3 vs. V4)

BF MP7 Nozzle/T-piece sealing Issue (V3 vs. V4) - Gel Blaster

Рет қаралды 2,664

3 жыл бұрын

Upgrading your MP7 with an alloy nozzle (with o'ring) is a highly recommended upgrade to maximize the blasters air seal.
The clear plastic t-pieces (V3) require a longer nozzle - LH AUG or Vector V2 nozzles are recommended or stick with the stock plastic nozzle.
The newer Nylon V4 t-pieces are the preferred option because you can use the more universal gen 8 alloy or cnc nozzles.
The nylon t-piece is definitely a must if you're wanting to upgrade to a metal barrel (also highly recommended!).

Пікірлер: 11

@alexgrovejones 3 жыл бұрын

Great video! It would be awesome if you did a full upgrade video of the v4. Cheers

@johnh3733 3 жыл бұрын

Mate....u just earned a sub

@detha123456789 3 жыл бұрын

This was the case with my vector and black hsg t peice. I used the barrel o ring from my 3dg barrel it's held in and sealed with sikaflex😂. No leaks at all

@user-mb1ef5ij5r 3 жыл бұрын

Hi at the starting of the video 0:02 i saw a gearbox with metal parts. Can I know the type metal parts u changed for the gearbox like metar gear , cylinder and ladder ? and is it for BF MP7 V3 ? cz i cannot find fit metal parts for them THANK YOU VERY MUCH

@gelballblasterhub2972 3 жыл бұрын

Metal gears are made for mp7. They are hard to find online now. Cylinder head is the same as gen8/9. Ladder is light blue polymer 14 tooth. I found that SHS ladders were too tight on the rails! A big design flaw. I'd Honestly recommend keeping the nylon gears, replace cylinder head and nozzle for better seals, chuck in m90 or m100 spring. Short stroke one or two teeth for faster ROF (will lose FPS but).

@rotor7475 3 жыл бұрын

my mp7 v4 only feeds /shoots when i tilt it upside down, any idea what could be the problem on my mp7?

@gelballblasterhub2972 3 жыл бұрын

Sounds like it could be a mag motor/mag wheel issue. The motor essentially turns the mag wheel which pushes the gels up through the mag. You may need to get a new mag. Ensure you don't overgrow your gels. 4 hours in water max. I personally grow for anywhere between 2-3hrs cause I use tight bores. There's also a plastic lip at the bottom of the tpiece which is meant to stop the gels from falling out of the blaster when you take the mag out. I'd recommend removing as it is an obstruction.

@rotor7475 3 жыл бұрын

@@gelballblasterhub2972 hmmm after doing a full gearbox and barrel check on the mp7, i really think the mag is the culprit, thanks to you!, i am able to assure my suspicion that it really is the magazine's motor that's giving my gun a hard time to shoot.