Definitely holding up. The green mower has been beat hard... still keeps going. Good luck with your build... send me some pics and videos when your finished. I'm on Instagram as mud farmer.

kzfaq.info/get/bejne/b5pxrcZ7tqucY6M.htmlsi=eN4uld6dM06ge4_j

Thanks man.. means alot. Definitely awesome when a veteran mower builder like you gives props.

@@mudfarmer You had the balls to post a fail and talk about it rather then hide it or lie. No build is perfect and that move gets my respect more then anything.

@@mudfarmer PS this video will pull more views if you made the Thumbnail a good pic of your rig. If your an Android user check out Thumbnail Maker and use the YT Studio app on your phone to edit video info and thumbnail.

Thanks, just changed it.

Awesome video keep them coming like to see some more your builds my next build is my wife refreshed her johndeer

Thank you.

Thank you.

I will make a short video on it soon. It would make it easier to explain.

4309 rs 3/4" center bore. First set I ordered came 17mm which won't work.

I change front and back. it has 5" on front and 4" on back. With taller tires it's probably little over 20mph.

I used angle iron . find me on Facebook, under Mud Farmer. Send me a message. You also can find me on instagram under the same. I have done a few lifted mowers , so I can send you some pictures of how I did it.

@@mudfarmer ok sure will

Thanks. For the motor pulley try to get as much pb blaster on the motor shaft above the pulley.let it set for a bit so it can get between the pulley and motor shaft. A puller is best way. I use my same home made puller as I used in my how to remove pulley from transaxle video. Try leaving the bolt out a half inch. Let the center of the puller rest on it. If you have a slap hammer puller. That will work too if you have the mower tilted up resting on the back fenders. Tires my go to tires are 22x11x8 gbc dirt devils. You can also use the search term 22x11x8 tires in google. There are few other companies that make a decent tire for a 8" rim. If you step up in rim I like kenda executioners. Let me know how you make out

@@mudfarmer Thanks man, since i didn't need the drive pulley i was pulling off of the 18hp briggs, i sawed off the belt pulley that extends off of it and got the motor out this morning after i got off work and got the new motor mounted up and its just wiring from here. Thanks for the info on the tires, i wanted to run rear tires on the front also to have that quad look and just more tire is better in my case, but i found out that is not so easy unless i welded a bolt with threads to the spindel or whatever its called where the tires slides on to. But for now i may just put aftermarket tires, possibly the ones you suggested. Thanks again for the help, hopefully i'll finish the project soon, ill post a video.