Nice work. I’m about to retire and start a project truck with my son. This is good inspiration.

No questions asked! Thanks for the hangover. Just kidding. Ian you did a fantastic job commentating on KOH.

MAF sensors are usually calibrated for the tubing size. I'm not sure what the R2.8 uses MAF for (fuel control? EGR?), but it's something you should keep in the back of your mind when you test drive it for the first time.

Go Ian, keep whoopin’ that truck’s ass! I know when I see you fabbin’, it’s as good as done! Press on sir! Stay safe mates!😊👍🏻😷

That is a beautiful project Ian!!! Congratulations

I love your builds. This one may be my favorite 😻

That’s really cool (haha...see what I did there)!!! Seriously awesome build👊🏻👊🏻! Love watching this series

Mr. Ian Johnson...Finally found you. Didn't know what happened to you for a long time. One minute Im following up on a Survival Suburban with Dual Axle Rear then you went missing and the show went right out the Exhaust Pipe. I couldn't continue to watch after you left. Guess its to Big Tire now...Awesome

That is just pretty doggone sweet to hear that purrrrrr!

I can't wait for the commanche.

Love the project!

too bad you could not find someone better than Ian for your video no Yukon gear & Axle for me ever again

Congrats

Ian , I'm wondering if it is possible to install a Honda 3.5 in a jeep ? New challenge for you ? Would make a great episode

Watched the wiring video and have a question……. How do you remove the body with the AC hooked up?

Nice , I'm looking for the rear cab corners and back wall to make my CK 7 into a truck . Any suggestions ?

Hair.

Where is your shop dog supervisor?

Wrangler yj 1991 years engine 4.0 pcm 56026982 need new number part for new pcm Thanks From BOSNIA

Whoever does the video and editing does a good job but whoever does the title to these videos must be confused I have no idea what you’re working on before I click on the video that would probably help get more clicks