I have a crank with a stripped thread so I thought I would bring you along to do the repair. please like and subscribe thank you!
Пікірлер: 21
@rtong122 жыл бұрын
Question: If I am repairing the left pedal instead (vs. the right in the video), does the coil and threading tap tool go in clockwise also? (I understand for the left side, the pedal tightens counter clockwise). Thank you.
@renzarlantico86252 жыл бұрын
What size off that re treader mate
@dangilliver8 ай бұрын
So I'd replaced the pedals on my Raceface Ride XC cranks and managed to completely strip the threads in the right crank (only the second time riding them), I was tempted to do all this myself and rethread it, but luckily I've managed to find someone selling the exact same crank spider on eBay so I'm just gonna swap it out and hope I don't bugger em up again!
@SYNTHETIC16083 ай бұрын
Yo is bike parts cheaper in your country than in philippines?
@dangilliver3 ай бұрын
@@SYNTHETIC1608 so this particular part cost me about £30 second hand on eBay, which converts to just over 2100 PHP for reference!
@mervinaurelio3235 Жыл бұрын
Pls send me link this item😊
@neilgoth1974 Жыл бұрын
How about installing helicoil on Shimano crank arm pinch bolts? I find myseld in a situation now that I've stripped those pinch bolt areas as I kept on removing and reinstalling for a deep clean.
@retrobikestuff760 Жыл бұрын
I don’t see why not pal, never had to do that you must have cleaned it loads lol
@neilgoth1974 Жыл бұрын
@@retrobikestuff760haha. I'll give it a go. Cleaned loads as in I've had the cranks for years moving between a few bikes as well.
@SaludfitnessPUNTOcom2 жыл бұрын
What link did you use to buy this
@retrobikestuff7602 жыл бұрын
There on eBay mate union brand I think
@arveevitug Жыл бұрын
Is the thread inserts size 14m?
@BramBiesiekierski11 ай бұрын
9/16 - 20 UNEF. Left thread on left side, right thread on right side.
@MoeySends Жыл бұрын
Is there a size on what thread you need to use on your crank?
@Mamudy Жыл бұрын
That is my question
@rockylocey4984 Жыл бұрын
9/16
@BramBiesiekierski11 ай бұрын
9/16 - 20. UNEF There are quite a few different 9/16 threads. These are relatively uncommon, when compared to the more common 9/16 UNC / UNF sizes.
@fuluk1693 ай бұрын
size of tap for helicoil?
@fuluk1693 ай бұрын
5/8"-20?
@Mamudy Жыл бұрын
link please 🙏 my damaged crank is 170mm left side but I do not know the size of the tool you used