This is one of the best videos I have seen over electronics

This was my question in the previous video, thank you for a great explanation!

Excellent. Great explanation.

Something that works super well, is using a ferrite bead in series with the gate resistor. (also available in SMD). If you choose these well, it will really knock down those pesky harmonics, while giving more room to keep the switching frequency a bit higher at the same time.

Outstanding demonstration, this is exactly what I was talking about in my comment on a previous video, this is the additional context needed to better understand the gate drive resistance selection. Well at least half of it, the radiated emissions are equally significant as conducted emissions demonstrated here. You are a great teacher, subscribed! It's difficult to know the right questions to ask when learning about subject material so when someone includes the hidden traps it's a little easier to understand the significance of component selection. It would be great to see this video linked with the others!

thank you very much for the informative presentation, big fan

Hi sir, Yes you are correct. We used this idea and worked for EMC RE to pass the limits. But this will increase loss and reduce efficiency.

Good explaination. Thank you.

Thank you

Very informative. Thank you very much.

Excellent and thank you

خیلی خوب و کاربردی بود ممنونم

What a excelent video, like always.

I think you missed to include the pdf in the description

Thank you very much sir

❤❤❤

Thank you very much.

Thank you.

Hey, what if I am getting certain freq oscillations in the rise time and it is causing failure in EMC testing. how do I overcome that any thoughts?

Sir this is for same resistor value for Turn on and off, if we use different resistor one for turn on and one for turn off with diode, How it will act??

Super

Hello, can you please share pdf and reference schematic of you eval board used on this explanation.

Is it possible to say at what frequencies this starts to be needed or necessary please ? just subbed hobbyist here ....cheers.

I don't know if you can help with this odd behaviour... I hade built a power supply that powers 2 external Hard Discs, based on the power available on computer's USB port. When computer starts up power supply turns on first HD (12VDC) and a few seconds later (after startup current settles) the second HD is powered. The power is switched with MOSFET transistors controlled by a PICAXE PIC microcontroller (powered by 5VDC). As soon as first drive is powered on, immediately the second MOSFET switches on, without any voltage at its gate (0V). Very strange! It should turn on a few seconds later when PIC applies 5V on gate? The PIC outputs are connected to MOSFET gates with 330ohm resistor to limit PIC current. The gates is also tied to ground with 10K resistor. If the loads (HDs) are not connected, circuit behaves correctly. (I also have LED/resistor across output to show on/off state). I fail to understand how the MOSFET can turn on without any gate voltage?

Sir how to reduce the noise in DC system with FPGA