Mine drift to left,had to move to rite to compensate, thanks you sir that help alot,newbie here,learning process...never give up 👍🇺🇸🇨🇱✌️

Wow this really helped me out with stable hovering. Used to violently drift after about 30sec of flight. Now it doesn't.

Nice! I've been wondering about this adjustment, and I'm gonna give it a try!

Thank you very much, this saved me from more crashes and expense.

After almost owning a 230S smart for a year. This actually worked for this version. Crashed it bad. Rebuilt it. Did a bunch of trim flights and calibrated the dam thing more times than I’d like to count. Though this was the only thing that worked!!! I’m also using a NX series transmitter for those who are curious. It works! Though it does jump “ hop “ differently when you enter this mode.

Thanks for making such a great video… Your explanation the filming everything really helps out. Big thank you

I re place the blade grips and it didn't fly after I replace the blade grips I did the servo leveling thing inside the book like what you said now it does great and I don't have the dx678 or 9 I just have the ready to fly transmitter that came with it and it seems to work out quite well thank you for your video appreciate what you do stay safe

Hi RC stuff I received this yesterday. I always thought it was an ugly thing but in reality it is a very nice and beautiful helicopter.

Hello everyone and Happy New Year ! I just received the Blade 230S Smart BNF equipped with the AR6250MHXA. How to insert the Bind Plug association socket without dismantling everything? In addition, besides the fact that my fingers do not pass and that I do not see the plugs, a plug is already connected to the BIND plug ..... My radio is a Spektrum DX6 G2 EU. All have a happy new year 2022!

So seems basically like the swashplate was uneven? Wonder if just adjusting physical links to level the swashplate would work too.

Is this basically doing smaller versions of trim? I tried this on my DX6i and I don't think it did anything

do you spend a lot of time in angle self leveling mode- this doesn't pertain to acro (fm1 & 2) does it?

I have this problem on my new blade 230 s (smart) does this method work there to? And If i use a spektrum nx6

Mines been stupid ever sense I bound it to my dx6e and off the ready to fly dxs..not sure why my stability mode doesn't work anymore.. thinking I don't have something right but don't know what

The trick is to use subtrim To correct the drift. Trim tabs should remain untouched. Sub trim only.

If I fly my with the batt there it is nose forward. move the batt back to the stop . My fly great this way.

I think this is not the right way. These steps worked for me perfectly : 1. Adjust the servoarms with the shown method perpendicular to the servo (eyeballing) 2. Adjust the swashplate to a leveled position by adjusting the linkages (swash leveller / eyeballing against a horizontal line on the wall for example) 3. Adjust the center of gravity to the best you can 4. Do the Calibration flight (hovering for 2 minutes or so with no wind) with a velcroed battery WITHOUT tightening the velcro strap or no velcro strap ! Done - Flies like pussycat

If you plan on flying in stability mode and being at beginner level forever than this works for a simple but imprecise cure. No point in explaining the correct way Anyone familiar with 3d flight knows this already

Now that I've been flying mine a bit could you not have just used forward programming and adjusted the flight controller. There's calibration settings and their for the drift… That's what I did and my 230 hovers perfect… And it was quick. But believe me I am no expert I did find the blade 230 had horrible tail rotor Hold… So I had to learn the PID algorithm and the numbers I programmed are nowhere near what the factory puts in. I now have a better tale hold I was getting large blowback when aggressive