Thanks for sharring bud. Nice!!

Dude.. driver looks good. Well done

It wouod be nice to paint the tub

On eBay, there are adapters that you take that on off switch slide it into a 3-D printed adapter and still mounted in the correct to my location

That front bottom plate has to be modified even on the brand new hot shot super shot and the hot shot 2 because it doesn’t fit in your steering, Roger are going to bottom out and scrape them on the bottom. You have to actually put two spacers in between the screws that are at the back of that and go up into the chassis. I use the Tamaya brand spacers they come in silver and blue and I continuously always have to buy new bags of those. I keep 50 of those things around to shim up every little screw that’s pertains to steering, and the rods that I use for suspension pins I never use the screws anymore unless you heat the screw up and send it into the model so that it actually cuts its own threads into the plastic. You never want to use a screw pin cold into the plastic because as the model sits, you’ll come back when they find all of your upper and lower suspension arms have cracked , I was taught that technique back in 1986 folks noticed that the plastics were a little different and threading the screw pin in would inevitably crack the round part of this suspension arms I believe in some of the directions they would tell you to threaten at time and then back it out the plastic

Ive bought ps30 for the paint body. Hopefully itll look good as a blue better than the plastic body blue