BLUEPRINT READING FOR WELDERS AND METAL FABRICATORS 1

Рет қаралды 36,679

hanging with heavy

Күн бұрын

a video series on blueprint reading for welders and fabricators. From basic lines and views and navigating a print.

Пікірлер: 22

@catfromtrigun 3 жыл бұрын

thank you for laying out the basics, appreciate your time with making this video

@jessecastro3551 3 жыл бұрын

Thanks for sharing your thoughts with me, wonderful knowledge

@hangingwithheavy2113 2 жыл бұрын

you are welcome it is my pleasure to help you out.

@kendrickscruggs3539 2 жыл бұрын

Great video

@mrandrewdennis1 5 жыл бұрын

Awesome video thank you for sharing.

@hangingwithheavy2113 5 жыл бұрын

you are welcome Andrew, make sure you check in next week for unit two. Hang with Heavy" and you will be able to read and draw basic prints.

@worldclassfabricationworkshop 3 жыл бұрын

thanks sir,, i am new learner, i wanna improve my fabrication drawing skill.

@beoptimistic5853 3 жыл бұрын

kzfaq.info/get/bejne/rKx0gMR5tprPh2w.html ..💐

@chenequawilliams1162 4 жыл бұрын

Your are great!!!! 1st year student

@beoptimistic5853 3 жыл бұрын

kzfaq.info/get/bejne/rKx0gMR5tprPh2w.html ..💐

@fredericknoel1948 Жыл бұрын

great mateeeeeeeeeeeeeeee thank uuuuuuuuuuuuuuu

@ianstorey716 2 жыл бұрын

I wish you would have repeated the answers when pointing out the lines but thank you it was a good video

@roberts1159 2 жыл бұрын

Any particular reason the side view was drawn incorrectly ?

@hangingwithheavy2113 2 жыл бұрын

I do not see the discrepancy, would you be able to point it out for me?

@noellwilson1273 2 жыл бұрын

I’ll just mention one point. If view D is correct, view A starting from the bottom where the 3” dimension line is, should have a solid line on the edge, a hidden line for the bottom section, a solid line for the edge of the top section, and a solid line for the edge of the thinner section. If view A is the correct one, the bottom section in view D should be cut off flush with the right edge of the top section. Another caution: These are the standard “views” in the US system of drawing. In much of the rest of the world, “Third angle projection” is used and the accessory figures are like a strong light projected an image into figures C and D. They sort of look like the same outline but some lines change from object to hidden and vice versa.

@metalhedjay 3 жыл бұрын

Please ad more echo

@hangingwithheavy2113 3 жыл бұрын

Dang Jay I am not sure I can do that, maybe more sheet metal! Thanks for watching

@orochimaru3950 2 жыл бұрын

Top view doesn't match the front and right view.... unless I'm trippin

@orochimaru3950 2 жыл бұрын

I see what he did.... he didn't specify it so it threw me off.

@nicholascarpenter5239 Жыл бұрын

I still don't understand why the bottom part of the right view jutted out, when the top view made it seem like the back side was flush. Error? Maybe. Questions would solve this IRL.