Great videos. I did a case with a full arch wax up and would have loved these tips before hand. I exported the case with only front wax up, then front and right side wax up, and then full wax up. I could then print multiple models to create Essex retainers for sections. I tried using mesh mixer to create shell temps but I think since I used hollow and not solid model the internal portions were filled in when printing them. Also not sure if it works with your printer but doing hollow models and selecting no raft but create internal supports prevents holes when printing flat. I use preform

Thanks Baron! Great video man

Thank you for your VDO.

Thank you sir

Is there a place that you get all of your libraries for the teeth? I'm searching from more shapes and sizes from. I feel pretty limited by the few selections they have in blue sky bio currently. Thanks a lot!

is it free to export from crown module ?

“I don’t want to sound lazy”. 😂You are a trip brother. You are anything but lazy. Thanks for helping out the digitally challenged. Again. Be well.