BMW E39 M5 Transmission Mount DIY

Рет қаралды 9,540

4 жыл бұрын

This E39Source DIY video demonstrates how to change the transmission support mounts / bushings on the 2000-2003 BMW E39 M5. It is also applicable to other BMW models.
PARTS:
(2) Transmission mount: 22316771221
(2) Upper nuts: 22316760944
(2) Lower nuts: 07129904862
E39Source website: www.e39source.com
Help support E39Source by donating: www.e39source.com/donate

Пікірлер: 22

@kohlbarnes2317 4 жыл бұрын

Thank you thank you thank you so much for creating an extremely throrough and informative video on how to do this!! Excellent work sir. Why do some people decide a shitty Nickelback song up way too loud is better than explaining what you are doing.... Top work.

@jonathanlicup1459 3 жыл бұрын

great job....

@willt718 4 жыл бұрын

nice ///M nato band!

@alexedward1250 2 жыл бұрын

Thank you for the detailed video. One question, the new polyurethane tans mounts do not seem to have the notch for the top slot, so it can tightened independently. I imagine the trick would be to hold the top nut while tightening the bottom nut?, any thoughts to share?

@E39Source 2 жыл бұрын

I would recommend stock trans mounts, though your trick on the poly ones sounds like it would work.

@alexedward1250 2 жыл бұрын

Thank you

@jonnygti 4 жыл бұрын

Hi mate, don’t suppose I could ask some advice about my E46 318. Basically my ABS, traction and hand brake warning lights come on as soon as I turn on the ignition and remain lit whilst driving. And today I started the car and no warning lights were on, I thought ok that’s great! Then 2 minutes down the road I pressed the brake pedal and got a weird noise for a few seconds and then all the warning lights came back on, but the noise stopped and the brakes carried on working fine after that? I’m not going to drive it now, just going to take it to the garage, but what do you think is the problem? I hope it’s not expensive!😟

@E39Source 4 жыл бұрын

Sounds like a problem in the ABS or ASC system. You'll need a scanner to scan those modules for codes and go from there. Blind diagnosis is a waste of time.

@reginaldjones6024 4 жыл бұрын

Txs

@imidzovic 3 жыл бұрын

Fun Fact: E39 530d uses the same Transmission Mounts, I just replaced them with same Corteco mounts used in this video. Unfortunately, that didn't solve my problem. I still hear thump when I hit max throttle and release it.

@erhodes8745 5 ай бұрын

Did you figure out what it was ?

@imidzovic 5 ай бұрын

@@erhodes8745 Yes! After I replaced the mounts, I did gearbox service (oil, filter and gasket), that did not help either, but then a guy from Bulgaria told me to use INPA to reset gearbox adaptation and that solved the problem!

@KiluminatiOG 3 ай бұрын

I have the same loud thump when I press the gas hard but I don’t have to let off to hear it, it’s once as soon as I hit the gas

@need4spe3dBeast 4 жыл бұрын

Just replaced this a few days ago lol

@sweetsuductress 4 жыл бұрын

Whenever I do this job, I always take the time to remove the shields to access the bracket bolts. I don’t believe in bending those aluminum shields at all.

@E39Source 4 жыл бұрын

That's fine too, but the shields are not at all hurt by bending them in any way.

@sweetsuductress 4 жыл бұрын

Yeah, I think I do it to get more room because I use a socket rather than a wrench.