BMW E46 320d Crankshaft vibration pulley replacement

Рет қаралды 38,594

Күн бұрын

This is a guide for Crankshaft Vibration damper pulley replacement on E46 320cd, 320d with M47tu/M47 engine. Hope that helps someone. Thanks for watching.
Big Thanks to "Noir Et Blanc Vie" for a fantastic music. You can find his KZfaq channel and also his music in KZfaq audiolibrary.

Пікірлер: 15

@alpinemobile5140 11 ай бұрын

By far, this is the best video on this subject!

@jamieem37 3 жыл бұрын

This is by far the best instructional video I have ever watched, thank you so much for the notes and I hope my replacement goes well which I will be doing the day after tomorrow :o

@tomasskucinsks7623 3 жыл бұрын

Nice write-up!

@whitedust696 3 жыл бұрын

I’m going to attempt this

@balistican1 2 жыл бұрын

great

@dan8789 2 жыл бұрын

Hi Did you need someone underneath the car holding the tyre iron when you were undoing and torquing the bolt? You must look after that engine as you have a lot of new parts ( water pump,alternator,starter motor & now crank pulley👍)

@straight_to_the_point7869 2 жыл бұрын

Hi, yes, car was sitting on axle stands and also supported on heavy duty 3ton jack, second person held tyre iron until flywheel teeth bite tyre iron, after that, second person came out from under the car and i was able to safely push hard and slacken crankshaft bolt. I am planning to keep this car for a long time so i did replaced all vital parts at once. N47/M57 engines are very good "bullet proof" engines. Also in my opinion E46's looks great and getting slowly rare too. Hope that helps. 👍

@albertpodgorski6665 3 жыл бұрын

Hi, is the crankshaft pulley from cranktechnics still working fine? I red loads of bad opinions about this brand. I have to change mine and I don't know which one to choose. Thank you for the video

@straight_to_the_point7869 3 жыл бұрын

Hi, Yes it is working fine without any issues. 👍

@SoAExile 3 жыл бұрын

Dude, I need advice asap, my crankshaft pulley snapped in half!!! Somehow the serpentine belt that runs the alternator and stuff must have jumped or some s*** on to the smooth part of the pulley. And the other belt for the AC just fell off. Can I drive it like this to local garage or is it too risky. Because I don't have tools at home to untorque the unbolt of the crankshaft pulley

@straight_to_the_point7869 3 жыл бұрын

I would not risk to drive without a drive belt, because your water pump is driven by this belt and alternator and steering pump as well. If the garage is too far, you might end up stuck in the middle of the road, because your battery will be able to run without alternator just for a limited time and steering without steering pump would be much more harder and mainly without water pump running you may overheat engine... If the garage is within a 1-2km you may risk it, but anything more than that i wouldn't.