BMW E90 Pre LCI to LCI Rear Conversion | Trunk & Taillights (DIY)

Рет қаралды 5,807

Күн бұрын

Upgrading the BMW E90 Pre LCI rear end to the LCI rear end, Quick and easy. Straight swop with depinning and my own adaptor box to trick the FRM into thinking everything is normal with the annoying LED DRL errors on the car | Pt2 • How to Code Your BMW A... - Coding out errors using BimmerGeeks ProTool
You can follow me Socials
linktr.ee/realpreshaanb
Affiliate Links to products used in this video
Trim Removal kit - geni.us/j9bXRK
Outer Taillight Right - geni.us/Qok0w
Outer Taillight Left - geni.us/YqkrD
BMW K+Dcan Cable - geni.us/TNxm
if you purchase these items using these links, I will earn a small commission which I really appreciate
Please like this video, leave your feedback in the comments
Subscribe to my channel and share this video as much as possible
Check out my Previous Video
How To Easily Replace Your BMW E90 Window Regulator
• How To Easily Replace ...
BMW E90 320d camo design Copywrited to Preshaan Briglall
Any unauthorized use of the vehicle (Design, or violation of the intellectual property act) will be met with legal action
00:00 Introduction
00:46 Intermission
01:41 Pre LCI Overview
03:39 Removal
08:47 Installation
12:40 Outer Taillights
16:17 Conclusion & Outro
#BMW #E90 #LCIConversion

Пікірлер: 14

@Realpreshaanb 6 ай бұрын

i have Finally done the LCI conversion on the E90... Super happy with how it turned out, yes there are a few things that were my fault, but as a whole, everything works as it should despite the cold bulb checks which you'll see in the video. please leave your feedback on the adaptor box and my little commentary in the edit... kzfaq.info/get/bejne/bKh0ZJidq53KiKc.html Coding Out the Bulb Checks

@justinbuice 6 ай бұрын

Nice work man! I always wanted to do this when I had my E90. I love the wiring graphics you made, plus your solution to bypass needing to code.

@Realpreshaanb 6 ай бұрын

Thank you brother 😁 it means a lot, this whole conversion changed up the entire car and i still can't get over it 😁 I'll be doing a follow up soon 😁

@LostPathfinder01 2 ай бұрын

Awesome video !!!

@jeshvikakamraj9051 6 ай бұрын

Neat 😎

@AzaelMahallon 3 ай бұрын

It looks interesting I just made my conversion from pre-lci to lci do you think that solves the fast flickering and the codes on the console?, greetings from Mexico

@Realpreshaanb 3 ай бұрын

Its 50/50, yes it eliminates the hyper flashing but the flickering and codes remain since it follows the FRM Bulb check procedure. It works to make the conversion operational but to eliminate the flickering and codes, the bulb checks will need to be coded out, video on that linked in the description and comments

@tommiejacobs4546 6 ай бұрын

Hi can you please share with me how to replace a diesel pump on a BMW 320d please?

@Realpreshaanb 6 ай бұрын

Depends on which pump you need help with... Is it the intank pump or the high pressure fuel pump on the engine block?

@PietroSarullo 5 ай бұрын

Hey bro, can i Connect The LCI cabel with the vfl cabels?

@Realpreshaanb 5 ай бұрын

I'm unsure what those cables are so i cannot really comment on it

@cocopops6911 5 ай бұрын

mine does exactly the same thing when i start the car..the lights flicker

@Realpreshaanb 5 ай бұрын

This is normal for LED Bulbs - BMW's bulb check system tests if exterior bulbs are working by sending a small current through them when the car starts. LED bulbs, having a lower power draw, may flicker during this quick check because the current might be too weak to activate them properly. To fix this, additional load resistors or special LED bulbs may be needed to simulate the higher power draw of traditional bulbs and ensure they pass the test without flickering or by having the Bulb Checks disabled by coding them off the car kzfaq.info/get/bejne/bKh0ZJidq53KiKc.htmlsi=M2UH_C8hy9VzNuvC

@cocopops6911 3 ай бұрын

never knew you replied back to my message..Thanks very much for the insite and reply..your videos are so helpful..thanks again @@Realpreshaanb