2016 BMW R1200RT/LC Air Filter Replacement 12k service www.pacmototours.com
Пікірлер: 58
@beemrdon528 ай бұрын
These are the kind of KZfaq videos that are helpful. Who wants to watch a guy riding around on a bike talking like a combination tour guide/ used car salesman. What is the point, other than clicks? Please keep these instructive vids coming...
@PacMoto8 ай бұрын
Thanks for the feedback!
@trailingarm63Ай бұрын
Thanks for the video, very helpful. What a bloody performance just to change an air filter! Obviously DIY servicing does not feature highly on BMW designers' list of priorities.
@PacMotoАй бұрын
It’s not particularly difficult, just tedious. Be patient and stay organized and you’ll get it done without issue.
@9mfire3 ай бұрын
Thanks for the video, greetings from Russia.I went to change it on my motorcycle, we will soon be warm.
@PacMoto3 ай бұрын
Good luck!
@keithe374 Жыл бұрын
Thanks for the information. Clearwater lights makes a replacement clip that’s metal for the side pieces. I have one on my RT as one of the clips was broken.
@PacMoto Жыл бұрын
Yes, they do. I broke one and fortunately found the Clearwater solution. I made a video of the installation too. Thanks for the comment!
@timothy4375 Жыл бұрын
Hi, Very helpful video. I just looked at it before changing my 2018 RT filter. That plastic filter cover is one very tight fit! I encountered (and overcame)one issue which I though may assist others. Reinstalling the filter cover (@ 6:50 minutes into), the rear was very, very snug against front of gas tank and filler neck breather tube. This left no room to properly reinstall and position cover over the two (rear) plastic tabs and rubber rim seal. So I ended up using a large screwdriver (while holding cover) to pry tank back just enough to allow sufficient room to correctly position cover. I also removed additional screws to move the R and L plastic fairing pieces away from the filter. Thanks again for the detailed video.
@PacMoto Жыл бұрын
Good idea! I will try that approach next time!
@gabrielperez96992 жыл бұрын
Good video!! Helps a lot to do the change of the filter
@PacMoto2 жыл бұрын
Thanks! There’s a bunch of Tupperware to deal with, but not overly complicated.
@grantbradley50842 жыл бұрын
I performed the same service yesterday,on my 2022 RT, at 3500 miles the filter really wasn’t dirty at all. ( I drove through gale force dusty conditions) I wish I had viewed your video. Took me a while but it’s all complete.👍
@PacMoto2 жыл бұрын
Yeah it’s not particularly difficult, just a bunch of plastic to remove to get there. Glad it all worked out for you!
@acruxalf12 күн бұрын
Very useful video. Thank you from Spain
@PacMoto11 күн бұрын
De nada!
@Chris-gi9ch Жыл бұрын
Surprisingly better then a Concours 14
@PacMoto Жыл бұрын
That’s almost hard to believe!
@Chris-gi9ch Жыл бұрын
@@PacMoto Yea, I nearly bought one until I saw a You Tube on it........Super ridiculous!
@carsyoungtimerfreak11499 ай бұрын
Good video. Checking this to help a mate of mine. I'll stick to Japanese bikes, a lot less hassle... All this jist to replace an airfilter...
@PacMoto9 ай бұрын
It’s not difficult, but it is tedious!
@frankpellegrino74482 жыл бұрын
This procedure is relatively simple compared to an air filter service on a Goldwing.
@PacMoto2 жыл бұрын
I’ve never tried it in a Gold Wing. The BMW isn’t difficult, it’s just a lot of screws and plastic to get to the filter.
@9mfire3 ай бұрын
Спасибо
@PacMoto3 ай бұрын
добро пожаловать
@idcdork2 жыл бұрын
Great video! I feel like I'll need to do this sooner than later. On the panel pieces where the 12 volt connector (right) or stereo controls (left) are.. how do you manage the wiring? Is there a molex/quick disconnect in place or do you just have to gingerly hold it to the side ?
@PacMoto2 жыл бұрын
I did not disconnect the cable from the panel. I just let it hang down gently. You could always zip tie it to keep it from hanging down if that makes you feel better.
@brettbaldi68642 жыл бұрын
Thanks for making the video, I am changing the air filter tonight and your video give a nice overview of the process. By the way, what seats do you have installed on your bike? How do you like them compared to the stock seat?
@PacMoto2 жыл бұрын
Fantastic, lots of plastic but not too difficult. I have Russell Day Long seat - I absolutely love it. Check them out at day-long.com. My wife and I did an Iron Butt on them last summer.
@tlexup Жыл бұрын
Great video, nice info for so far. I wonder if you can tell me about the RAM ball you fitted on the steering yoke. I'm looking for this setup and I could'nt find nothing about it. You're bike looks really nice mate :-)
@PacMoto Жыл бұрын
Yes, I bought in the UK from Nippy Normans. Here is the link: www.nippynormans.com/gps-accessories/ram-specific-ball-kit-for-r1200rt-lc-r1200rs-lc-r1250rt-r1250rs
@richardjohnson7858 ай бұрын
I have a 2018, are screws for side pockets different than the bike shown? What is the purpose of removing the screws in pockets? I didn’t see moving it out of place in the video. On mine there is one screw in the pocket and it appears that the 2 screws on the speaker cover must be removed. Also I see in other videos of removing the radio panel, is that required?
@PacMoto8 ай бұрын
Basically you need to loosen enough of the screws to allow you to spread the panels to reach the airbox. Be especially gentle with the side panels since they have plastic clips that hold them in place. I broke a clip one time - as a result I made a video on how to repair it. Good luck!
@beemrdon529 ай бұрын
Do you use crash bars? I dropped mine and it made a mess of the side case. So I am going to install rear crash bars for the bags. Already have engine protection bars installed.
@PacMoto9 ай бұрын
I never installed them on my RT but if I get another one I’ll use the Illium Works crash bars. Good luck!
@Crazygaucho622 жыл бұрын
Wow that filter change is challenging, Love R bmw ( nostalgia? ) my dad had an old R50 used to ride on the tank with him ….I know they probably really well made and reliable , thinking about getting one soon , are they too complicated and overengineer like most of the German products nowadays….what’s your honest opinion from an old biker to another …?
@PacMoto2 жыл бұрын
Frankly the air filter replacement seems difficult, but it’s just removing a bunch of plastic to get to it that’s the challenge. I love my R1200RT and R1200GS. They are really great bikes!
@deanbuxton5973 Жыл бұрын
Thanks for the video. I just finished mine after watching this. Nothing was difficult. I just kept asking myself, who designed this process? The extented procross proves the engineers that create these stupid designes are not the people who have to work on them.
@PacMoto Жыл бұрын
Exactly!
@skiman39112 жыл бұрын
T.y for the vidéo! Can you tell what kind of seat please…look so confi.
@PacMoto2 жыл бұрын
It’s a Russell Day Long seat. Check them out at day-long.com.
@AJTStuff7 ай бұрын
They are all the rage, but I’ve had two and ended up selling them. They don’t work for everyone. Having said that, RDL is a wonderful company to work with.
@andrewloeffler4323 ай бұрын
So, basically, when you are done taking the entire bike apart, you can change the air filter at the same time.
@PacMoto3 ай бұрын
Haha, pretty much!
@ParisRome2 ай бұрын
Hi, which seats you have? It seems very confortable. Thanks
@PacMoto2 ай бұрын
It is the best seat ever! It’s a Russell Day Long custom seat. You can find them at day-long.com. Cheers!
@williambowen6471 Жыл бұрын
what are those seats and where did you get them?
@PacMoto Жыл бұрын
Highly recommended. Russell Day Long day-long.com
@andrewloeffler4327 ай бұрын
Geez, now I just have to set aside 15 hours to remove every panel on my bike to change the air filter
@PacMoto7 ай бұрын
Haha yeah it’s not difficult but a little tedious.
@tonylittle1370 Жыл бұрын
A little tedious?
@PacMoto Жыл бұрын
Not difficult but certainly tedious.
@beemrdon528 ай бұрын
I'm relegating air cleaner exchange to a 50,000 mile service interval. If I had a GS and constantly running it on dust blown dirt roads yeah, I'd do it at 12,000 mi.
@PacMotoАй бұрын
I kinda feel the same way about a valve clearance check.
@5150ToddB2 жыл бұрын
Ridiculous...
@PacMoto2 жыл бұрын
There’s a bit of Tupperware to get to the air filter….