BMW X6 (E71) REMOVE and Wrap Window Trim the Right Way with 3M Chrome Delete

Рет қаралды 19,266

3 жыл бұрын

Getting that Shadowline look can be cost-prohibitive. Or, you can do a low effort messy, choppy looking topical wrap where the rough edges of the wrap are visible to the discriminating eye. Both versions didn't work for me. I took every piece of window trim off my BMW X6 and wrapped them while they were off the car. Even on close examination it's very hard to tell it isn't factory Shadowline trim. Do this technique and never have to walk up to your BMW knowing there are flaws everywhere in your wrap-job. Know that it is a flawless wrap! Everything worth while takes time.

Пікірлер: 9

@ryanjpappas 3 ай бұрын

Great video. New X5 M for my fiance. I saw the weather stripping gap was so small and then came across this video. It makes much more sense to take them off the car. Welp..here goes nothing

@clevelandaeromotive 3 ай бұрын

How'd it turn out?? =D

@herlegz6969 3 ай бұрын

Those front side marker lights need some shadow line treatment with the diodes too.

@Mr1970827 6 күн бұрын

Very very good job... I have a 2015 5 series and I think I'm going to do the same thing...

@clevelandaeromotive 6 күн бұрын

Thank you! Good luck! Hope this helps!

@IRTEHLEETOKNPBB 2 жыл бұрын

Good step by step. Informative video. Thanks!

@clevelandaeromotive 3 жыл бұрын

IMPORTANT NOTES 1. Do not even slightly bend or bow the big piece of trim over the top of the front windows. Any additional resistance because of uneven pressure can lead to clips not being able to hold back additional “spring pressure” and constantly popping off. That or, allowing rain water past the first layer of weather protection, the top gasket. 2. Again on the front top trim piece, It’s best to reattach the top gasket to the trim piece while it’s off the vehicle. Then reattach the trim with the gasket already in place. 3. If the plastic grommet(s) that hold back the gasket(s) on the top of the front windows keep falling out after completion of the project, an appropriately sized expandable plastic wall fastener can be inserted and will hold fast. 4. All work should be done with windows down.