Bowl Demonstration #1
Introduction and comments
0:01 Introduction
0:35 speed recommendations
1:03 water comments
Start piece with hole in middle
1:12 start the first hole
1:46 anatomy and technique thumbs vs fingers
2:40 start hole with thumbs
3:39 finish hole with fingers
4:02 decision for bowl form starts at floor
4:16 “Frisbee” tip/technique of counteracting wheel spin
Establish deepest part of curve of bowl
5:12 pull out curved bottom with curved fingers
6:00 compression of bottom for looks, strength
Early height efforts start with broad touching
6:54 first raising of wall, broad hand shove
8:14 second raising of wall, also broad hand shove
8:36 shift from broad hand shove to smaller fingerprint pinch
Remaining height with fingerprint pinching
8:55 first fingerprint raising
9:52 rim correction technique with sponge
10:34 second fingerprint raising
11:40 water using comments
12:00 third fingerprint raising
At full height, but generic form, hand and tool shaping starts
12:48 first hand shaping of rim
13:08 hanging string curve structure guideline
13:36 sponge shaping, several gentle changes
14:11 precleaning the bottom (pot not finished yet!)
Final shape refinement with tools
14:39 rib shaping from inside
15:16 rib shaping from outside
15:40 correcting the unnecessary bump (“shelf”)
Summary
15:46 summary of steps