Brake system flush using one-person brake bleeder (Allstar Performance Bleeder Bottle)

Рет қаралды 7,187

Жыл бұрын

In this video, I demonstrate how I used the a one-person brake bleeder bottle from Allstar Performance to perform a brake system flush without any assistance. While I did this procedure on my 3rd Gen 4Runner, the majority of what I show applies to any vehicle.
Begin Disclaimer
This video is for demonstration purposes only. It is me demonstrating how I performed this modification. I make no warranties, nor do I take any responsibility for damage to your vehicle. Always seek advise or assistance from a trained professional.
End Disclaimer
Parts used:
Allstar Performance ALL11017 Bleeder Bottle with Magnet and Check Valve , White - Allstar Performance ALL11017 Bleeder Bottle with Magnet and Check Valve , White www.amazon.com/gp/product/B00...

Пікірлер: 13

@chrisryan8863 3 ай бұрын

This was a great video. Great job keeping that truck in good condition!

@grandvalleyfishslayers1279 3 ай бұрын

Shouldn’t you tighten up the bleeder valve before you remove the bottle?

@hotbusa08 Жыл бұрын

Love your 4runner and your videos are very informative thanks

@brandontorres7557 9 ай бұрын

awesome vid dude!!

@mpasaa 3 ай бұрын

I kept having issues with air leaking at the hose to valve connection and zip ties didn't help so I gave up and used my backup tool....my wife LoL! Two person is so much quicker and easier in my opinion.... doesn't take that long and I don't need to deal with hose to valve connection that simply won't seal correctly....

@Skoot61 Жыл бұрын

- Greetings OverlandEd, I'm planning to do a 2013 tundra Brake replacement soon with new rotors, pads and calipers... BTW - I do like the the Callahan - Red Calipers however, the link you posted indicates that they're currently unavailable and don't know when or if this item will be back in stock. So, I think I'll just get new remanufactured calipers and paint them red myself. But, I'd like your opinion on a question of brake bleeding. Do you think it would be beneficial to flush out the brake system of the master cylinder and, brakes lines with *new* DOT 4 fluid with the old calipers still installed in the attempt to remove the majority of old contaminated brake fluid till it runs clean and clear *before* installing the new calipers? I'm thinking it would minimize the possibility of leaving behind more of the old fluid mixture when purging and bleeding out the entire brake system through the new calipers. Thanks, -Skoot

@theoverlanded Жыл бұрын

Flushing the brakes with the old calipers might be a good idea.

@gibstera5580 Жыл бұрын

Thank you for sharing

@raczyk Жыл бұрын

How do you know no air is going back into the system through the bleeer valve? Would a cheap vacuum pump on amazon work batter than just a catch bottle?

@XenomorphLV426 5 ай бұрын

Check valve

@luchforte 5 ай бұрын

One suggestion, I would add a little brake fluid in the catch bottle just enough to cover the hose in the catch bottle maybe 1/4 cup to be safe so air doesn't go into the caliper. I'm sure this won't happen but figure you will have left over brake fluid so adding 1/4 cup in the can won't hurt. Thanks for the video.