Bridle Joint on the Band Saw
Рет қаралды 10,967
10 жыл бұрынBandsaw Bridle (Open Mortise and Tenon) Joint *
Watch as I show you how to cut bridle joints (open mortise and tenon joints) on the bandsaw.
Bandsawn bridle joints can be cut effortlessly with the help of a very simple aid. I'll show you this in action, allowing you to make multiple joints all with one fence setting.
For the 'perfect' joint, I knife the joint lines, and finish the joint shoulders by paring with a chisel. However, a very nice joint is achievable straight off a well tuned bandsaw with a good blade.
See my series 'Bandsaw Know How', and learn how to tune your bandsaw before you try this joint:
( • Band Saw Know How )
* This video has been posted again, after it was kindly pointed out that my spelling had let me down! Thank you Bob.
As with all machinery:
DISCONNECT FROM THE POWER SOURCE WHENEVER GUARDS ARE REMOVED.
USE SOME COMMON SENSE.
@1golham 9 жыл бұрын
u did perfect job :)
@didiervalencia3824 8 жыл бұрын
hi wath its the mesure of the saw? good vid!
@mitchwoodwork 8 жыл бұрын
+Didier Valencia Hi. That was my 14" Jet band saw. Happy woodworking, Mitch
@PietroMaker 6 жыл бұрын
☺
@rosswillmeyer1992 2 жыл бұрын
What size blade are you using
@mitchwoodwork 2 жыл бұрын
Goodness me this was a long time ago! I can't remember for sure but I would think probably a 5/8" 4tpi skip tooth or similar. It's not particularly important and mainly affects the fed rate. A 1/4" 10tpi standard blade would be fine if the rip cuts are taken slowly.
@oldcodger 8 жыл бұрын
Hi Mitch- Curious as to why you used a high fence for such a narrow piece of wood?
@mitchwoodwork 8 жыл бұрын
Hi Marc, Golly it's such a long time ago. There isn't any technical reason to use such a high fence, something close to the component height or higher is fine, as long as it's accurate, is good.
@oldcodger 8 жыл бұрын
That's the problem with the internet, things are around longer than one can remember. I used the stock fence, and the bridle joints are really good. Thanks for the tip on the shim. Worked great. As much as I would like to have cut the joints by hand, my skills with a tenon saw need more improvement. The bandsaw method kept me moving ahead with the project. On to the raised panels next!
@mitchwoodwork 8 жыл бұрын
Marc Sitkin It's important to keep the momentum up on a project, that way you'll have time after to practice with the tenon saw 😉
@nineoneten 4 жыл бұрын
Fingers too close to the blade for my liking, otherwise good job.
@mitchwoodwork 4 жыл бұрын
Cheers. Yes, I should be more careful when filming
QAZSPORT TV / ҚАЗСПОРТ TV
Рет қаралды 590 М.
Small Barn Workshop
Рет қаралды 1,9 М.