Briggs & Stratton 17.5hp Intek Engine Tear-Down

No video

Briggs & Stratton 17.5hp Intek Engine Tear-Down | Thrown Rod Cause of Failure?

Рет қаралды 7,037

TheOutdoorPowerGuy

Күн бұрын

Пікірлер: 9

@derekbeaver3003 6 ай бұрын

Reminder to turn your volume down after this video

@joeymitchell3863 Жыл бұрын

Dangit!! You cut the video at EXACTLY the point where I needed to see how the governor comes out! Mine was knocking badly but nothing was broken, the rod bolts had come loose (or maybe weren't tightened), but I shut it off before anything actually broke. Cheaper to replace the rod (cylinder is pristine) amd even the crank if necessary, than to buy a new engine. But FIRST I have to remove the brass governor sleeve/bushing and NOBODY shows how. Could you please take a minute and describe how?? Thanks!

@RimjobHimself 11 ай бұрын

Did you find out?? My dad wants me to fix a 16hp Wich suddenly made some bad noises and shut off and now he says it sounds like it has no compression and also that it sounds like it keeps spinning around after he lets go of the starter button. In all fairness I'm not keen to do the job but I'm at least gonna have a look before I recommend him to buy a Chinese knock 9ff engine for 450usd.

@JamesSmith-jr2rc Жыл бұрын

I'm surprised the customer admitted it ran with no oil.

@PeteyMcSavage Жыл бұрын

Question I have same engine if I don’t run it at full throttle is that better for engine or does it cause a dramatic loss in air cooling

@spinDYL 2 ай бұрын

What oil would you recommend for that type of motor? I have a 2010 lawn tractor and I used 5w30 synthetic and it's burning oil, I was wondering if I should use thicker oil. Thanks.

@TheOutdoorPowerGuy 2 ай бұрын

5w30 is too thin, in a Briggs if temps are above 40F outside ambient, use only 30W and nothing else but straight 30W small engine oil.