Einbau eines Bugstrahlruders in ein Motorboot der Marke Regal 8,3 Ventura - vom Ausschnitt bis zur Probefahrt
Пікірлер: 13
@torstenhansen43082 жыл бұрын
Thank you for the video. Your method for cutting the hole in the hull works with thin hulls but not as well on thicker laminates. For those you are better off with a router on a shaft similar to your marking tool. I recently installed a tunnel in an old sailboat with a 25 mm hull thickness using the router method and it worked flawlessly. No grinding is required and the tunnel fits perfectly the first time. I credit ‘She’s the Captain’, a Danish KZfaq channel with the idea. He has done two tunnels, the first one very similar to the boat you are working on in your video and this is the one where he uses a router.
@Maximus.K3 жыл бұрын
Das erste gute Video das ich über den Einbau eines Tunnels im Netzwerk gefunden habe. Viele Dank für eure Mühe. Beste Grüße. K.W.
@123croy3 жыл бұрын
gutes video- jetzt traue ich mir das bei meinem segelboot auch zu
@philipprosenkranz91635 жыл бұрын
Selten ein so befriedigendes Video gesehen.
@motorseglerragna86934 жыл бұрын
Sehr schön dargestellt.
@CH-rl1fe3 жыл бұрын
Perfekte Arbeit
@dinomaus15 жыл бұрын
Sauber gearbeitet.👍
@kapitanlamprecht190710 ай бұрын
Welches Harz wurde denn zum laminieren verwendet, Epoxi oder Polyester?
@anjabretschneider8594 жыл бұрын
Klasse Sache. Wie weit unterhalb der Wasserlinie muss das Loch gebohrt werden?
@yachthafenmarinaraderbauer77484 жыл бұрын
Ideal wären so ca. 25 cm LG
@vetdoc353 жыл бұрын
Gute arbeit. Wenn man kein Antifouling drauf will wie würde dann der letzte Schritt aussehen?