Building a huge shower, Backer board to waterproofing and pan.

Рет қаралды 3,672

23 күн бұрын

SUBSCRIBE Learn how tile the right way
Building a huge shower, Backer board to waterproofing and pan. Huge, monster shower installation from studs to waterproofing using modern materials and traditional mud floor combined to create a waterproof shower. This shower has an area for a tub, the shower floor and main floor a both heated with radiant electric heat by Schluter Ditra Heat floor warming system. Wallboard used is a lightweight foam board by Laticrete Hydro Ban Board, used on the shower walls to create a water tight environment suitable for a shower. The very large shower floor was created with a level area where the tub will sit and a sloped area for the shower portion, sloped to a Schluter Vario linear drain. The floor was floated with deck mud and then covered with Ditra heat membrane for the heat wire element, then sealed with a sheet membrane as required in a wet area. A very large format 2'x4' porcelain tile will be used on the shower walls and a 12"x24" porcelain tile will be used on the shower floor. This video time lapse shows the entire installation from the studs and the waterproofing layer and the shower floor area including the heated shower floor. All tile installed by Sal DiBlasi, Elite-tile Company, in the Boston North Shore area. This video contains affiliate links, which means I will receive a small commission if you click on the product link. #tile #transformthetrade #howtotile #installingtile #howtoinstalltile #laticrete #mapei #Schlutersystems #diy #construction #ardex
👉 👉 👉PDF Floor installation guidelines sowl.co/s/wWd2d
Free PDFs 👇👇👇
Leaking Shower? sowl.co/5oAfm
Find a Contractor sowl.co/s/jtgoa
Failure Spot Bonding sowl.co/ZvQBH
🙂 This is my Amazon Store 🙂 www.amazon.com/shop/saldiblasi
🌲 Link Tree 🌲
linktr.ee/saldiblasi
☕ Buy me a coffee ☕
www.buymeacoffee.com/saldibs2
📷Camera Equipment 👇
DJI Action 2 Power Combo amzn.to/3xA5fMH
DJI Action 2 Dual-Screen amzn.to/3Qvk8IX
DJI Pocket 2 Creator Combo amzn.to/3mUr1pu
👇 Some of my favorite Tools 👇
Float amzn.to/2tdEpN2
Rubbing Stone amzn.to/2QrgRfh
Notched Trowel 1/4 x 1/4 x 1/4-inch amzn.to/36bq5mQ
Notched Trowel 1/2 x 1/2 x 1/2-Inch amzn.to/2Q5e90g
Notched Trowel 1/4 x 3/8 x 1/4-Inch amzn.to/39j1caB
Super Dust Collector - WaleTale amzn.to/2MDuVkK
Black Nitrile Gloves - 6 mil amzn.to/2SJQ6FZ
Margin Trowel amzn.to/352MYHx
Mortar Mixer amzn.to/2ZxYqtF
4in Sandpaper for Stone Polishing amzn.to/2ZB2skT
Polishing Rubber Backing Pad amzn.to/2srikdy
Montolit 63P3 24 Inch Tile Cutter amzn.to/2MDoFt l
DEWALT Wet Tile Saw amzn.to/2QqpO8O
Rubi Thinset mixer amzn.to/39VmNWV
Grabo Pro Lifter
amzn.to/3BBO5ys
IQ 7" Dustless/Dry Cut Tile Saw IQ228
amzn.to/3wFE3w0
Opt into NTCA’s VIP Text Messaging program for training opportunities. Text “NTCA” to 31996 or Visit (For Industry Professionals only) widget.smsinfo.io/v2/ae58812b...

Пікірлер: 39

@weekendwarrior3420 21 күн бұрын

Now if something happens Shluter, Hydroban and Mapei are going to blame each other :-)

@SalDiBlasi 21 күн бұрын

Nothing will happen and if it does I will back it.

@cjg7346 12 күн бұрын

I do the pre slope method, waterproof(fabric + liquid just to be safe), final mud layer, then shlutter ditra to the drain… I will try this method too!!

@cheverev 19 күн бұрын

Awesome video! Why wouldn't the homeowner spend the extra money to insulate all the walls, especially the one with the water lines?

@javierc.salazar512 18 күн бұрын

Nice work Brother Sal. Take care and stay safe.

@SalDiBlasi 18 күн бұрын

Thanks 👍

@daytonpyro 19 күн бұрын

i REALLY wanted to see Sal do his work over at the STUD PACK job. maybe for their house.

@moonpiespotlight4759 16 күн бұрын

Fix that terrible tile job.

@I-TILE 21 күн бұрын

Ohh yes. That’s a big one Sal. Nice job 👍

@SalDiBlasi 21 күн бұрын

😊👍 Thanks

@fishynut8252 21 күн бұрын

I got tired and a sore back just watching that video! ;)

@SalDiBlasi 21 күн бұрын

😊👍

@daytonpyro 19 күн бұрын

sal is a beast. i WISH i had half is energy

@daytonpyro 19 күн бұрын

no joke. that thing is huge. wow..

@SalDiBlasi 19 күн бұрын

😊👍

@mizquierdo31 20 күн бұрын

Awesome job here. How did you handle that little sloped area from the tub area to the bench?I would expect that little area to pitch toward the center of the shower area so that it could run to the drain but I know you said you were putting large tile on the floor so that would be tough to tile without reliefs there (which may not look good). Did you just keep the same slope in that corner as the rest of the shower pan (which would direct the water to the bench)? Hopefully what I’m asking makes sense!

@rainmaker3700 7 күн бұрын

That curb height would annoy the F-out of me, I would be stubbing my toe on it constantly. Tile work looks awesome though.

@BillJones2 7 күн бұрын

Great job!!! Is there slope in the tub area?

@interesting7906 21 күн бұрын

Amazing job as usual Sal. What's the reason to leave that stick in the middle of the mud bed?

@SalDiBlasi 21 күн бұрын

Foam screed. pitch under the tub is 1/8 per foot. Shower area 1/4 per foot.

@brianbacon3106 7 күн бұрын

@@SalDiBlasiif you had floated the walls with mud would you have used foam screed board? Would you have left it in the walls as well? Nice job!!

@BenJohnsonDotNet 20 күн бұрын

Amazing. Must have cost a fortune!

@user-ll1pe5wb7d 21 күн бұрын

Hello. Can you tell me please which of these thinset good for setting tile and uncoupling mambrane, Keraflex SG and Laticrete 252

@SalDiBlasi 21 күн бұрын

Either will work, but the sg is a large format tile mortar (H.T.E.) and I have found these types of mortars don't do as well with transfer when setting membranes. the Laticrete might be a better choice in this case. They are both lower end mortars but both meet ANSI A118.11

@greg6372 19 күн бұрын

can you recommend a wet-saw for professional use?

@ericmichalski5791 17 күн бұрын

Hey sal how did you flood test the floor with the tub drain??

@franciscobarriga1885 21 күн бұрын

Would it have been better if you installed Kerdi band and corners after installing shower floor membrane?

@ivanpuskaric6851 20 күн бұрын

yeah, I was wondering the same?, or it makes no difference?

@hereticxxx9317 20 күн бұрын

The order doesn't matter. Just needs a 2" over lap. Doing the membrane last is better though, it stops knee prints and foot prints from forming

@SalDiBlasi 20 күн бұрын

What hereticxxx9317 said

@michaelprimeau4900 14 күн бұрын

Sal, whats the unit in the shower floor? Valve, sensor, recirc?

@SalDiBlasi 14 күн бұрын

Valve for the tub

@moonpiespotlight4759 16 күн бұрын

I'd show this to my wife if this was me, "see what I did to earn this money you keep thinking grows on trees? now when I get home you know why I go into a coma after dinner".

@SalDiBlasi 16 күн бұрын

😊👍

@jeffreycarlson1882 21 күн бұрын

Hi Sal, I think you help a lot of people raise their skill levels. I know I've learned a few things. Thanks for that! One question - you installed the Hydro-Ban floor fleece over the Schluter corner strips. I would have thought it a bit safer to do it the other order. Do you think that order is arbitrary in this case? Looking forward to seeing this job progress!

@feeblewrk5788 20 күн бұрын

He has addressed this in another video and manufacturer says there is no order of operation when it comes to doing the corners/strips over or under the floor fleece

@SalDiBlasi 20 күн бұрын

What feeblewrk5788 said, order does not matter per manufacturer recommendation.