🇩🇿🇩🇿Thank you, gentlemen, for presenting and bringing the idea closer to helping to make a cooker that works in the sun. You have all my respect and appreciation. Thank you to all of you and to the lady who appeared with you in the video.

Awesome guys! Great video!

Amazing work !!!! Thanks for sharing this low tech, hope to build one ;)

Great video thanks for sharing

Aye m8’s, excellent work!

This is amazing

Design idea: (actually, two, which will depend on your system design intent) 1) The focal point will tend to spot heat, so instead of projecting directly onto the rib form, create a larger outer round tube onto which the focal area will project, with the form tube placed inside of, and offset away from the focal point, and interstitial void filled with oil, so the oil will be directly heated by the focal point, and distribute the heat uniformly across the inner form tube, basically a tube within a tube with the center tube open at the ends. 2) Perhaps even better, use only the focal point tube, without an inner tube, filled with oil, themostatically circulated via hydraulic hose to an insulated reservoir tank, from which hoses distribute the heated oil to 'jacket' of the mold, which would allow you to create any shape you want, or just heat beams for softening for bending, 'remotely'. This way your 'parts' need not be positioned at the focus, but perhaps on a table or the ground. You would have to allow for a bit of expansion in the system, but a coil of 19mm copper tubing is cheap on Amazon. That way you use your reflector 'thing' to heat the oil, transfer the oil to mold with a 'jacket', and you could have a huge, long reflector, and direct the heat where you need it, via the oil, while upping your overall thermal mass.

🎉 Much success! It is something that I was looking for if the plastic could melt with the sun and I already found you that it is possible! I will also make my design to share it from Mexico!

I wished to join you in the work to gain experience thanks to you

I would like to see you build a bolt together bridge heck of an engineer project what say you

where I can get one of those solar cooker ?

What is the name of that glass ?

The things are hiding only potato😂😂😂eating!

What is the name of the reflecting thing you use for making parabolic mirror

Hope you didn't pay much for that plasma cutting? Old mate controlling the height was unique but the cut's were terrible.. Although, can't expect a perfect job from from a homemade 'plasma table'. He was obviously, looking at the ground clamp, using a very cheap plasma torch..? Table was built well though besides the ability to control the height.

g