So in the last jointer video it turned out there were two things yet that needed slightly more work...one was needing the blades to be closer to identical than the 1/32 they were off...they are now down within around 2 thousandths of an inch between both sides and the one blade slight tilt side to side...ie that is where the 2 thousandths of an inch came from. That should be fine I think...I hope so anyway as I do not want to keep playing with it unless there are issues with the cut quality, and since it looked ok with the 1/32" off, I am pretty sure even closer to the 2 thousandths of an inch should be fine.
I also added in some cardboard angles to the dustbin with staples and tape and that should solve the chips not getting sucked into the dust hose.
Those were the last two very minor issues that I knew of...so now it should be a fully working tool. :)